How Do You replace the hand brake lever on the South African (Nissan Build)
Uno 1100 Fire (1992 Model) 1108 cc Engine Spec?
The Handbrake Lever doesn't hold up into the Ratchet part anymore and doesn't stay up when handbrake applied as the parts are worn down over the years.
I tried Banging out the Pivot at rear of the handbrake lever but can't see what holds the pin in place and wont move, Is there a Split Pin Or Washer Holding it?
Thanks Walter
There is an adjuster under the car just under where the handbrake lever is.
There is a screw on the hand brake handle inside the cabin. Just take off the leather that is covering your handbrake lever, and you will see it.
$31 in canada
The maximum speed of the 1961 Fiat 1100 4cyl 55hp is 75 MPH.
43 bhp is the power of the fiat 1100 1956 engine and its maximum speed is 83 mph.
the bonnet lever on a fiat brava is by the clutch pedel and has a red handle this may be the same on the bravo
Behind the handbrake lever there is an ashtray Take out ash tray Losen off smallbolt (3mm alen key) and you will see adjuster nut Ensure your car is on flat ground and wont roll away Release handbrake and tighten up adjuster nut till you get around 3 or 4 clics when you pull the lever up Check you have not adjusted to much by putting in first gear and lift clutch to just past biting and feel for back brakes sticking on Hope this helps G
Uno 1100 cylinder head? 30nm 90degrees then another 90 degrees
The technical data for the 1972 Fiat 128 1100 and 1300 was a 1116 cc engine. The maximum speed was 135 mph.
What is the mains and big end bearings torque setting for uno 1100 engine
check brake fluid level.
71 mph.