What makes you think a tube in the FI system needs cleaning? Have the computer scanned for a fault code. This code will tell you what system is being effected. Use this as a starting point to try and diagnois the problem. Unless you know what you are doing, do not just throw parts at the problem. You could end up spending lots of money and still have the problem. If you do not know how to diagnois the problem, take it to a professional.
it could be an issue related to your oxygen intake check oxy sensors if check engine light is on.
Trouble code P1537 means: Intake Manifold Runner Control Malfunction (Bank 1 Stuck Open)
The engine is choking. My '89 did it. Check the throttle body. It might need cleaned out.
It will cause the check engine light to come on with no benefits.
no, door locks have nothing to do with check engine light.
our 97 rl had a epa recall that fixed the problem they took out the intake manafold and cleaned it. It is a epa mandated repair at no cost to you. It also made the engine smoother and better milage
.The check engine light can be reset, after you install a new air intake, by removing the instrument panel fuse. The fuse can be located in the fuse box
check your sensor on the back of the engine block and under the intake manifold, passenger side. check your sensor on the back of the engine block and under the intake manifold, passenger side.
Need to check the 4 corners on the intake manifold. It is common for the intake to leak engine coolant.
It's the icon / graphic of a an engine, upper right hand area of the instrument panel.
how many check ball locations on a 1995 ford windstar
Check the black hose between the throttle body and intake manifold.Check the black hose between the throttle body and intake manifold.
If your check engine light is flashing when the engine is running that means that an engine cylinder misfire has been detected ( if you are going to drive it in for repair avoid any rapid acceleration / braking , you can damage the catalytic converter )
There isn't an individual fuse. It is run by the engine computer. Check the vacuum line running from the intake to the cruise servo.There isn't an individual fuse. It is run by the engine computer. Check the vacuum line running from the intake to the cruise servo.
If your check engine light is blinking with the engine running that means an engine cylinder misfire has been detected . You will need to have your Ford Windstar scanned for any trouble codes to help diagnose and then repair the problem . You can drive it in to have it repaired , just drive in a moderate fashion ( avoid any rapid acceleration or deceleration because you can damage the catalytic converter )
On a 2001 Ford Windstar the check engine light looks like a picture of an engine just to the right and a little bit lower than the ( O/D OFF light )
get an engine diagnostic check, a lot of different problems can contribute to your situation.
you have a cylinder misfire
Water is in your engine. Check intake and head gaskets.
You may need to check your idle air control valve on the tbi or check forvac leaks
Turn on the ignition and do not start the engine. The light will come on unless the bulb is burnt out or someone has removed it.
There are 2 knock sensor on the 5.3L engine. And they are under the intake manifold. To get to them you will have to remove the whole top of the engine- INTAKE MANIFOLD. Why do you think they need replaced???? check engine light came on for 2 sensor
Crack in intake or exhust, or belt glazing- Check all the intake and exhust bolts.
check your pvc. If that is not working your engine will blow the oil out somewhere.