The best place to find an engine diagram for a Chrysler Sebring would be in the owner's manual. If you do not have your, contact Chrysler or check your library.
Start with 4.5 and check the dipstick.
You need a scan tool to properly reset the check engine light.
A local auto supply store can reset it for you.
The only proper way is with a scan tool.
The engine light stays on when the engine computer has detected an emissions related failure and set a code.
Have it checked for codes, That is the same as the check engine light.
Depending on which engine is in the 2006 Chrysler Sebring has, the engine takes between 4.5 and 5 quarts of oil. Check the oil with the dipstick before adding all of the oil, and add more as needed. Do not overfill.
You can use a scan tool or unhook the battery after repairing the cause of the fault.
With a scan tool.
Since the Sebring has spark and compression , check the crank sensor, and the timing belt. If the timing has jumped or the sensor is bad then the engine will not start.
Check engine light, rattle noise, low power, change in fuel economy,
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
check for a broken motor mount.
The 1999 Chrysler Sebring has an overflow bottle on the passenger side. The bottle has markings on the side to show low and high coolant marks.
The dipstick is a tool that only the dealer has. The owner can not check the fluid.
Coolant temperature sensor circuit high. Check the sensor near where the upper hose attaches to the engine to see if plugged in.
With a scan tool, at a parts store (ie Autozone does it for free), or possibly by cycling ignition key on, off, on, off, on and counting the blinks.
it means take the car to a dealer ship and get rid of it lol... no have a system computer check on your vehicle it can be anything from low oil to a major problem
pour down the same tube you check it with
Check your grounding on your temp sending unit.
You need a code reader or a scan tool.
Common brake problems on a 97 Chrysler Sebring can be caused by leaks, worn pads, and stuck calipers. Check your brake system as problems can cause a serious accident.
Check with your local auto parts store. If they can't get it, call the Chrysler dealer.
If it started flashing after the water pump, it is possible that the timing belt/chain is installed improperly.