I had the same problem. Except that the transmission was not shifting as well. It was the transmission control module. It cost me about $450 to fix at the dealership 4yrs ago. I have had no problems since.
The Chrysler Town and Country speedometer sending unit is located on the back of the transmission. The sending unit will be in the upper right-hand corner of the transmission.
There is no speedometer cable. The speed signal comes from transmission and abs speed sensors. Chrysler last used a cable in the 1980's.
Town and country vans have never had speedometer cables. The speedometer gets it's signal from the transmission computer.
A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.
On a 1989, the speedometer signal comes from the sensor in the housing where the passenger side axle shaft goes in the transmission.
check to see if thers a speed sensor unit failure from the transmission.. Had this problem on a Caddy
It does not have a speedometer cable. The system is all electronic. There is a sensor at the passenger axle output housing of the transmission.It does not have a speedometer cable. The system is all electronic. There is a sensor at the passenger axle output housing of the transmission.
It doesn't have a speedometer cable. The speed signal comes from the output speed sensor.
VSS (Vehicle Speed Sensor) failure.
Switch on the side of the transmission was bad. Possible output speed sensor, it is on the left side of the transmission towards the rear. Two wires in the connecter.
There is no speedometer cable on a 1990 Chrysler New Yorker. The speedometer is electically driven by a speed sensor mounted on the transmission. often the contacts are just corroded and some electrical cleaner will fix it right up. Other times the sender will have to be replaced. They are available from major Auto Parts stores like NAPA, or from the dealer.
There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.