Yes.
In most cases, yes. If the circuit breaker continues to trip when there is no fault in the circuit, it may be failing and need to be replaced.
Owen Smith sucks balls
SF6 circuit breaker
There is a heated bimetallic strip that provides a time delay small overload protection. When its contact makes, it energizes a coil to trip the breaker. Some breakers are mechanical, though. There is a coil that trips the breaker instantly on large overload.
Copper, Brass and Aluminum.
A circuit breaker is a safety device that is put in an electrical circuit. When something fails, or shorts out, the circuit breaker "senses" the excessive current and automatically opens (or breaks) the circuit. They are used in homes, as well as some electrical devices. They are different than a fuse in that a circuit breaker can be reset. A fuse on the other hand, has to be replaced once it opens up. I hope this helps you. for more info, here is a web page about circuit breakers: <a href="http://www.wisegeek.com/what-is-a-circuit-breaker.htm">Ciruit breakers</a>
fuses or circuit breakers
An electrical safety device that can be reset and used again fits the description of an electrical circuit breaker.
An electrical safety device that can be reset and used again fits the description of an electrical circuit breaker.
3 pole circuit breakers are used for 3 phase lines
Certainly not in the case of high-voltage circuit breakers. Probably not in low-voltage circuit breakers, as copper is a better conductor and has a higher melting point.
Circuit breakers.
It's not safer, but it is more convenient.
SF6 circuit breaker
Circuit breakers prevent excessive current from flowing in the circuit by "tripping" when the current exceeds the circuit breaker rating. This causes the current to be cut off, and is used to protect the wiring as well as the appliances.
fuses
The same name breakers as the manufacture of the load center.
There is a heated bimetallic strip that provides a time delay small overload protection. When its contact makes, it energizes a coil to trip the breaker. Some breakers are mechanical, though. There is a coil that trips the breaker instantly on large overload.
Circuit breakers do the same thing as fuses. They interrupt current flow when a certain preset point is reached. The difference between circuit breakers and fuses are that circuit breakers are resettable and reusable, whereas fuses are one time devices that must be replaced after they blow.