How do I locate the heater blend door actuator in a Ford f150 pickup
Is there any difference in replacing the heater core in the 2002 as opposed to an earlier model such as the 1997 ?...or is it pretty much the same job ?
How do I replace the block heater in my 1998 F150 4.6L?
It is nnear where the heater core pipe enters the block. It is where a distributer would have been before EFI.
Is the 1997 F150 Transmission is the same as the 1999 Expedition
heater core hoses not hot
The most common cause of this failure is a broken blend door. Check heatertreater.net for diagnostic information and an inexpensive fix.
As long as the numbers match on side of trans the only problems you will have is the vss was moved to the rear diff in 1998 so the 1997 would need an entire wire over but if the f150 is. 4x4 then the speed sensor is in the transfer case which means your fine
There really isn't a heater control valve. The coolant flows through the heater core at max pressure and temperature is controlled by controlling the amount of air flowing through the heater core. This is the function of the blend door and this is a fairly common failure on Ford trucks. Check heatertreater.net for diagnostic information and suggestions on how to repair the system.
Go to hospital take he/she to the hosipitstal
No, a 1997 Ford F150 doors will not fit on a 2001 Expedition. You will need to get a door that is made specifically for the Expedition.
You have to re-torque your spark plugs to 25 ft lbs. Common problem with Ford trucks
1997 ford f150 fuel pressure specs
you dont, there is no back door on a 1997 F150.
The airbag module for the 1997 Ford F150 is located in the passenger side kick panel below the dash. It is silver and black in coloring.
6x8 ALL DOORS
If you bypass it correctly you will just no longer have any interior heat. Simply disconnect the heater hoses and connect them together. Connect the Inlet hose & Outlet hose going to the heater core together using a connector that you can purchase at most auto parts stores. By doing this you are simply routing the coolant away from the heater core. WARNING: Do not plug either of these hoses!!!!
Try flushing the coolant system out
Take it 2 a mechanic. :D
some possibilities are. low coolant level, open thermostat, pluged heater core,
block heaters are not standard on f150's. Thus if it was ordered with the option, dealer added or aftermarket installed it may have a block heater. Best way to find out if there is a block heater is to look very closely behind the grill and look for a plug that looks like a male end of an extension cord.
The 1997 Ford F150 4.6 liter engine throttle position sensor is located on the top of the transmission. The sensor will be connected to the fuel injection rail.
Your heater core might be clogged or otherwise inoperable. Videos for unclogging a heater core can be found quite easily on Youtube.
Inside the fuel tank