0
Compression ratio in foot lbs-1993 Chevy s10 pickup with a 2.8?
Wiki User
∙ 12y ago
factory recomeded compression ratio in foot pounds for a 1993 Chevrolet s10 truck with a 2.8 engine?
Compression ratio in a vehicle usually refers to the difference of cylinder displacement at top dead center versus bottom dead center. For example: if the volume is 1 cubic inch at the top of the piston stroke and 10 cubic inches at the bottom of the piston stroke, 1/10=10:1 compression ratio (or is it 9:1? Close enough for government work.)
Foot pounds is a measurement of torque. The two most common measurements of torque on a vehicle is either the twisting force exerted by a vehicle's engine (torque/hp engine specs) or how tight a bolt is supposed to be turned (lb/ft of torque specs for a bolt).
Other than the fact that compression ratio and foot pounds may be used to describe a vehicle's engine attributes, they have nothing else in common.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the compression ratio of a 83 Chevy c10 pickup?
Need to know what size engine it has to answer correctly.
What is the compression ratio of a 1974 Chevy 350?
8.5 to 1 compression is factory stock.
What is the compression ratio of a 1968 Chevy 350?
10.5-1
What is Compression specs for 1974 nova 350?
Compression ratio on a 1974 Chevy 350 in a Nova was 8.5:1.
What is the compression ratio on 1978 305 Chevy engine?
8.3:1 is stock
350 Chevy compression?
The compression ratio of a 350 Chevy engine usually ranges from 8.0 and 9.0 to 1. This provides a good balance of fuel economy and power.
How do you id rear end gear ratio in 80 Chevy pickup?
You can refer to your user manual to ID the rear end gear ration in 80 Chevy pickup.
Stock compression ratio 1977 454 big block Chevy?
9:1.
How do you find the gear ratio on a 2003 Chevy pickup?
Supply the vehicle identification number to the nearest dealer and he/she can tell you what ratio you have.
How do you increase the compression ratio of a 1996 Chevy caprice94-96 Chevrolet caprice 9c1 police package car?
with higher compression pistons
Will a Chevy 350 heads fit a 283?
YES. That is a direct bolt on with no problems. The heads will bolt on, but the compression ratio will be different. Depending on which heads and which pistons, the compression ratio could be a lot different.
Will rear end from 1999 Chevy pickup fit a 1996 Chevy pickup?
It depends on the gear ratio of the rear ends. You can find this out in the glove compartment of your truck. It should tell you there. Hope this helps you out.
