0
Could anyone tell me were is the timing belt cover on a 2.7 intrepid?
Wiki User
∙ 14y ago
This engine does not use a timing belt, it does use a timing chain instead which is inside of the engine behind the front cover
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is 3.3 intrepid oil pump located?
The oil pump is in the timing cover and is driven off of the crankshaft snout. You have to remove the timing cover to replace it.
Where is the camshaft sensor on a 1997 Dodge Intrepid 3.5L?
drivers side in the timing cover just before the valve cover.
Where is the camshaft position sensor on a 1994 Dodge Intrepid?
On the driver's side, in the timing cover in front of the valve cover, if it's a 3.5L. Please specify if its a 3.3 or 3.5L
Where is the Dodge Intrepid water pump?
On the 2.7 eng. it is behind the timing chain plate in the very front of the engine. It is also run using the timing chain.
Where is camshaft position sensor located on 2002 intrepid 2.7 engine?
It bolts to the timing cover on the front of the engine on the driver side. It is a three wire sensor.
How long should it take to replace the crank seal and timing cover gasket on a 2001 Chrysler Intrepid?
If it is a 2.7l engine it is a good four hours, and that is on a good day
Where are the cam sensors on a 97 Dodge Intrepid?
ON A 3.5, IT SITS ON THE TOP OF THE TIMING COVER, DRIVERS SIDE OF VEHICLE (OVER THE CAMSHAFT SPROCKET). ON A 3.3, I'LL GET BACK TO YOU...
Where is the cam sensor located on a 2000 Dodge Intrepid 2.7 engine?
Front driver side of the engine. It goes through the timing cover just above the serpentine belt.
How do you replace the water pump on a 1995 Dodge Intrepid 3.5L?
If it's the same as my 97 3.5L it is located behind the timing cover. This is a 3 piece cover. Remove all 3 pieces, remove timing belt, and you can change water pump. Make sure not to mess timing up while your in there. I missed it by one tooth and had to go back in to fix it.
How do you replace the water pump on a 1996 Dodge Intrepid?
You have to take out the electric fans. then take off the belts and then you will have to pull the hurmonic balancer off take the timing cover off then take off the timing belt. the water pump is located in between the cams it is bolted on with 3 boltsand looks like a pully. this is for a 1996 dodge intrepid with the 3.5 v-6 you
If there is no timing mark on the timing cover of a 350 how can you set timing?
you can purchase an aftermarket timing tab which bolts to the timing cover.
Can water get in oil through water pump or timing belt case?
It can get in through the timing cover. That does car does not have a "timing belt" cover, but it has a "timing chain cover." There is a BIG difference, as a timing belt cover does not have coolant and oil running through it, but a timing chain cover does have both coolant and oil running through it.
