Nissan Altima
Vauxhall
Crankshaft Sensors

Could there be problems accelerating after new crankshaft sensor fitted?

596061

Top Answer
User Avatar
Wiki User
2005-09-11 09:34:23
2005-09-11 09:34:23

It could be a dirty up throttle plate but most likely they screwed up the crank sensor, take it back to the place you had it serviced, tell them to make it right, if they give you any crap treaten to call The Buereau of Automotive Repair, (This will strike the fear of God into any sensible mechanic) they will most likely fix it at no charge to you at this point, and if not then DO call the Buereau they are in the government listings in your phone book, this agency employs agents who are experianced former mechanics, tell them your touble and they will investigate it

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I have a 2006 Cadillac CTS. What are the symptons of the crankshaft sensor going out?

User Avatar

Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing.

User Avatar

I have been having problems with finding the crankshaft sensor, what should i do or what can i do?

User Avatar

2001 Honda accord it might be the crankshaft sensor or the knock sensor you might have to check the spark plugs too

User Avatar

The crankshaft sensor is by the crankshaft pullie (the balancer)

User Avatar

Yes there is a crankshaft sensor

User Avatar

The crankshaft position sensor is located behind the cam gears. you have to remove the timing belt to get to it. If your not having any problems don't fool with it. This is actually the camshaft sensor, the crankshaft sensor is down near the crankshaft and is the wire that runs up over the timing belt inside cover. It is very hard to reach and not many diagrams on it.

User Avatar

98 Hyundai crankshaft positioning sensor location

User Avatar

how to tell if my crankshaft sensor is not working

User Avatar

were is the crankshaft sensor on 2005 mitsubishi lancer

User Avatar

No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.

User Avatar

There is no such thing as a crankshaft sensor. There is no such thing as a crankshaft sensor.

User Avatar

The sensor in the distributor is the crankshaft position sensor.

User Avatar

You have to remove the starter motor to view the sensor position Depends on which engine is fitted 4 cylinder 1.8 petrol is at the front of the engine at the flywheel end.

User Avatar

Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt

User Avatar

The 1992 did not use a crankshaft sensor.

User Avatar

the position off the crankshaft sensor

User Avatar

That year did not use are even have a crankshaft sensor.

User Avatar

If the crankshaft sensor is dead the engine will not start

User Avatar

DI Direct ignition cartirage and crankshaft sensor other than that bombproof

User Avatar

The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.

User Avatar

The rear crankshaft sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order for the sensor to be visible.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.