The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.
G sensor is right side of frame Could you be a little more specific please?
There are a couple of reasons why a 1986 Isuzu will not idle. One reason could be the oxygen sensor and another reason could be in the fuel system.
It is a Throttle Position Sensor
The sensor will be by the accelerator pedal
how to change engine block sensor
Yes, there is a diagram of the oxygen sensor location of a Isuzu Trooper. This diagram can be found in the cars maintenance manual.
how much is corperator for a 1986 isuzu pup 2.3l
how do you replace coolant temp sensor on a rodeo
The 1990 Isuzu 2.8 liter engine MAF sensor can be found on the firewall in the engine compartment. The sensor will be on the passenger side of the firewall.
on the exhaust manifold.
Could be low fluid,a bad sensor or transmission going bad.
It may be located in the airbag sensor control unit.
it is low coolant temperature, could be the thermostat could be the sensor for coolant temperature.
The check engine light for the 2001 Isuzu Rodeo often comes on because of a sensor that is damaged or malfunctioning. The most common sensor is an oxygen sensor and when reset, this often allows the light to be reset.
En donde esta localisado el sensor de coolant en la isuzu rodeo 2002 4 cilindro
Could be in the trany sensor/gear or the speedo itself
On exhaust manifold.
on the right side of the engine
The oxigen sensor can be found on the exhaust manifold or exhaust pipe
under the hood
Isuzu part number 8-97258-523-0(MSRP $193.86) crank sensor is on the right side(passenger) of the engine block, just behind the mount.
The Isuzu Rodeo can have 3 or more oxygen sensors. The oxygen sensor delivers information to the powertrain module.