The Answer to this question is: The density is not measure Kilonewtons. That is because "Density" is defined as the mass per unit volume.
The Density of steel = 7850 kgf/m^3
Depending on the type of steel you are referring to, between 7,450 - 8,000 kilograms per cubic metre.
Your Poo And you are a Poo
0.28 lb/cubic inch
Between 18.3 and 19.6 kilonewtons.
A cubic meter of steel weighs almost 3 times more than a cubic meter of aluminum. Density of steel is 7.85 g/ cm3, aluminum is 2.7 g/ cm3
Given that the density of mild steel is approximately 7.85 g/cm3m and 1 cubic millimetre is 1/1000 of a cubic cenimetre, the weight of one cubic millimetre of mild steel is 7.85/1000 = 0.00785g i.e. 7.85 milligrammes. -- Kev Gill
It will range between 73.3 and 78.4 kilonewtons.
The density of steel is 7850 KG/M3
A galvanized iron is similar to steel; it is material that composed of cold-rolled and hot-dip galvanized mild steel. It has 7850 kilograms per cubic meter density same as a steel.
A cubic Meter of Steel is heavier than a cubic meter of wood because Steel is more dense than wood therefore there is more of it in the same cubic area. But if you compare a pound of wood to a pound of steel they will in fact be the same weight. :op
You need the density of your material, say you had a cubic metre of water which has a density of 1000 kilograms / cubic metre, then it would be 1000 * 1 = 1000 kg If it was 1 cubic metre of steel, density 7850 kg / cu m, then it would be 7850 * 1 = 7850 kg
The density of high-tensile steel, such as the steel grade 8.8, typically ranges from 7,850 to 7,900 kilograms per cubic meter (kg/m³) or 7.85 to 7.90 grams per cubic centimeter (g/cm³). The density of steel can vary slightly depending on its composition and specific alloying elements. It's important to note that the density of steel is a property that can be influenced by factors such as temperature and processing conditions. The values provided here are general averages, and for precise engineering applications, it's advisable to use the specific density values provided by material suppliers or manufacturers.
Steel is not a standard alloy: its composition is varied to meet different requirements. As a result its density varies. A cubic metre of steel will have a mass of between 7750 kg and 8050 kg.
0.28 lb/cubic inch
The alloy used for welding should be similar in strength to the bulk material being welded. Otherwise there will be stress concentration at the junction between the two alloys. This problem is somewhat reduced when the metals mix during welding, if the weld point moves slowly enough.
Stainless Steel 321 has density of 0.29 pounds per cubic inch, which is 8.0272 grams per cubic cm.
1%
Use steel density of 7850 kg / cubic metre, express all dimensions in metres. > volume = 1 * 1 * 0.02 = 0.02 cubic metres, then: 0.02 cubic metres @ 7850 kg / cubic metre = ( 0.02 * 7850 ) 157 kg
spider silk's tensile strength (per unit of density) is about ten times that of steel cable.