in level trigger mode, the input signal is sampled when the clock signal is either high or low whereas in edge trigger mode the input signal is sampled at rising or at the falling edge.
lever triggering is sensitive to glitches whereas edge trigger is non sensitive..
example: latch for level trigger and flip-flop for edge trigger
This question is gay.
US = Up Stream invert level DS= Down Stream invert level If detailed on a manhole, the difference being the gradient of pipe in chamber from one end to the other.
Both are a means of delivering water at an increased pressure. The difference between the two is how they are installed. The water pressure in an elevated water tank system increases as the height of the tank goes higher. As a simple example, get a length of transparent plasticÊhose and fill it with water. Hold both ends of the hose at level then slowly raise one end higher than the other. Water will flow towards the lower end. For a booster pump system, there is no need for elevation. The pump itself is capable of increasing the pressure by pushing water fasterÊusing a hydraulic valve system.
Put the spirit level on a flat surface, check that the bubble is in the middle of the little glass vial. If it is, the machine is level.
AIM/PURPOSE: To describe the instruction for the calibration of Dumpy Level to ensure that equipment is maintained in fully serviceable condition, is safe to operate and meets environmental requirements. FOR THE CALIBRATION OF DUMPY LEVEL The method described below is to be used on-site check prior to use as to the accuracy of the Dumpy level between calibration checks. This Work instruction shall be conducted at the commencement and completion of a contract. 1. Drive two pegs, "A" & "B", into the ground six metres or more apart 2. Set Dumpy up at "C" 3. Shoot a level at "A" and "B" 4. Relocate Dumpy to "D" and shoot a level at "A" and "B" 5. Record the appropriate result in the workbook. (Levels shot at "D" should be within ± 10mm of "C") D A C B
There is a pressure difference in the building only if the system referred to is NOT a closed system. In a closed, pressurized pipe system the pressure is the same throughout. If open, assuming 3 stories x 10 feet/story, one would add the pressure equivalent to 30 feet of water head.
in level trigger mode, the input signal is sampled when the clock signal is either high or low whereas in edge trigger mode the input signal is sampled at rising or at the falling edge. lever triggering is sensitive to glitches whereas edge trigger is non sensitive.. example: latch for level trigger and flip-flop for edge trigger
what is the difference between elementary and basic
difference between business level strategy and corporate level strategy?
what is the difference between Re oreder level and EOQ
It's like the difference between a biopsy and an autopsy.
it is difference between the water level from head race and tail race
A: it does not apply to only flip-flop but to all kinds of logic circuits where a [+] transition from a less negative to a more positive level occurs [-] and the other way around meaning a +/- transition must occurs to transfer states.
hi
what is the difference in between original ground level and natural ground level
the level of wealth
Your level of committment
my mom