0
Difference between On-the-Job Development and Off-the Job Development?
Wiki User
∙ 14y ago
The difference is that with "on the job" training, you're on the payroll, actually performing a duty within the company while learning the job. With "off the job" training, you learn in a school or training program, which may be separate from or a part of the company.
Wiki User
∙ 11y ago
Wiki User
∙ 14y agoOff the job trainnig is normally in a classroom/workshop covering theory and practical but can include, depending on the learning taking place actual experience of a situation
On Job training - in work learing as it happens in real time
Wiki User
∙ 11y agoJob training has been divided in to two broad categories.
1. On job training
2. Off job training
On job training is given to the employees when they are performing the regular official tasks. On job training includes:
A. Orientations
B. Internship
C. Acquaintanceship
Off job training consists of following types:
A. Lectures
B. Case Studies
C. Simulated program instructions
D. Visual training
E. Laboratory training.
Off job training is very expensive.
Wiki User
∙ 12y agoon-the job training is cos effective for the employer since the person contineuos to work whilst learning.
Add your answer:
Earn +20 pts
What country possesses Easter land offthe coast of south America?
Easter Island belongs to Chine
Why isn't the moon a source of light?
The moon is not a source of lightbecause the moon is just a rock reflecting offthe sun to power lightso it can shinne as bright as the sun
Did the captain of the Titanic jump offthe Titanic?
No. When Titanic sank, Captain Smith went down with the ship.
Where can you buy a from Littlebigplanet sackboy?
besides the ones that come with the speciaal edition offthe games they also sell them at Wallmat Target amazon and Ebay and many other retailors and online sites
Can you take tires off car and block it up offthe ground and stop them from repossing it?
You can try but they still can repo the car if it is out in the open. Make arrangements before it is too late. Good luck.
1993 f250 4x4 we have already replaced the ignition switch and the key will turn the truck over but will not shut it offThe switch feels loose or free no retention any ideas?
adjust the rod that goes from the switch/key (runs on top of the column) To the switch at the base of the column !! Switch at the base is adjustable !!!
99 aurora lights blink on and off when the car is offThe headlight time delay box relay clicks while it does this.replacing the time relay box under the dash did not fix problemwhat else could it be?
I had the same problem. The dealership replaced the entire turn signal switch on the steering colum. That fixed the problem
What is a ball that curves to the right called in golf?
A shot that starts straight, or to the left and then works right is known as a fade. (For right handed golfers) --------------- For right handed golfers a Slice is a shot that curves to the right and a Hook is a shot that curves to the left.
My new house window that slides open vertically is getting stuck. I removed the window but I don't know how to fix the issue.?
If the window frame and casing is made of wood and the temperature is hot with humidity it will swell and therefore the window will stick. Your best choice is wait for the humidity to decrease and your window will slide up and down fine. Otherwise you will have to shave a little offthe sides of the casing or frame.
Why would your 1993 buick century 3.3lv6 be hesitating when you go to take offthe more gas you give it the slower it goesi tried dry gas and fuel injector cleaner and it didn't work?
When a car gets sluggish when pressing on the accelerator, it seems as though there is an issue with the fuel system. This could be the car not getting enough fuel from the pump, issues with the filter, fuel line or even one of the seals.
Why does my 99 silverado engine continues to run after key is turned offthe radio turns off the runninng lights stay on and have to pull the fuel pump relay to kill also remove the running light fuse?
It's called dieseling, and i had the problem in my 87 Caprice for a while. A quick solution is to shut your truck off while it's still in gear and put it in park when the engine completely shuts off.
Why should charcoal fires not be used indoors?
when charcoal burns there is excess carbon causing soot to be given offThe above answer is correct in that there is too much carbon available for the amount of oxygen, which can result in the production of carbon monoxide gas. This gas is colorless and odorless and extremely toxic. A victim of carbon monoxide poisoning will usually simply fall asleep, and will die due to respiratory failure.Do not burn charcoal indoors or in any enclosed space.
