Check the screws next to the wires and see what color they are if they are green, black, and red then do what i say next, if not you're screwd.
just connect the red/black/green wires in the holes in the flip switch and be careful not to touch the wires just the protective covering and inert them they should auto lock in there...if not just screw them in.
It is very simple to install a dimmer switch in place of a regular light switch.
Regular Dimmer will work.
No, the dimmer switch needs its own individual circuit power supply to feed the fixtures connected to it. The black of the second dimmer switch can not be connected to the red wire of the first dimmer switch. Now if you are talking about using a common "hot" to feed two dimmer switches then this can be done. The neutrals will be common also. So what you should have is two black wires connected together with the incoming "hot". Two neutrals connected together with the incoming white. The red from each dimmer is then connected to its own individual fixture load.
12v switched source. such as headlight switch or dimmer on the dash.
If the hot is connected to the supply and it is turned on and the switch is turned on and the neutral not connected this could be quite true. Connect the neutral to the supply neutral and shut the switch off. Now the only reading that you should get is the hot supply.
pull the dash
I think the term you're looking for is "regular variable."
Don't connect the red wire or you will die.
There should be two wires coming from the dimmer switch unless it is a 3-way dimmer. The wires should be labled line and load on a normal 2-way switch. The line load is connected to the incoming power wire. the load wire is then connected to the wire that goes to the fixture. If you area replacing an old two way switch, then it will hook up exactly the same as the original switch, except for the fact that you will have to connect the pigtail wires of the switch to the other wires that used to be under screw terminals. I hope this answered your question. Thanks, Ben M. There should be two wires coming from the dimmer switch unless it is a 3-way dimmer. The wires should be labled line and load on a normal 2-way switch. The line load is connected to the incoming power wire. the load wire is then connected to the wire that goes to the fixture. If you area replacing an old two way switch, then it will hook up exactly the same as the original switch, except for the fact that you will have to connect the pigtail wires of the switch to the other wires that used to be under screw terminals. I hope this answered your question. Thanks, Ben M.
Dimmer switches go bad, more often than regular switches.
120 volt xenon bulbs are fully dimmable just like a regular incandescent bulbs, using regular old 120 volt dimmer switches.
Id=result_box Como faço link do botão interruptor dimmer Rover 25 </ font> </ SPAN> </ SPAN> </ P>