Best Answer

What year the vehicle is would be helpful and what engine you have.

User Avatar

Wiki User

โˆ™ 2009-11-29 19:42:44
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Distributor wire placement Chevy s10 blazer?
Write your answer...
Related questions

What is the Wire placement on distributor of 305 92 Chevy?


What is the plug wire placement on the distributor cap of a 1996 gmc 5.7?

what is the plug wire placement on the distributor cap of a1996 gmc 4.3 v6?

What is the spark plug wire placement order on the distributor cap for a 1967 Chevy 396?

It should be the same as the small block.18436572.

Where is the ignition coil on a 1998 Chevy blazer?

On top beside the intake on passenger side of vehical... You can trace coil wire from distributor to find

Where is the distributor cap on a 1996 Chevy s10 blazer?

It is in the very back of the engine. Just follow a plug wire from the spark plug to the distributor cap. It is hard to see. All the plug wires start at the distributor and then hook to each plug.

Is the spark plug wire placement the same on a points distributor as it is on an HEI distributor?


How do you wire a fuel pump pigtail on a 97 Chevy blazer?

How do you wire a Pigtail for a Fuel Pump on a 97 Chevy Blazer Thank You EVa

What fires the distributor?

where does the hot wire come from going to the distributor on a chevy 350

Chevy Blazer Electrical problems?

Chevy Blazer electrical problems can be caused by a brunt wire or shortage. For a proper diagnoses, contact a certified mechanic.

How do you wire trailer lights on 1997 Chevy blazer?

with wires

Where is the ignition coil located on a 2000 Chevy Blazer?

It is located just left and back from the air intake as your looking from the front of the engine. It has a wire that runs to the Distributor cap. It has two electrical sensors on it as well.

Where is the crankshaft sensor on 1995 blazer 6 cylinder S10?

Chevy did not use a crankshaft sensor in 1995.If it won't fire then I would check the ignition module in the distributor and more then likey replace it. Also check the ignition coil and WIRE / coil wire.

1984 Chevy s10 blazer radio wire diagram?

need diagram

Diagram of spark plug wire placement on disributor cap of 1993 GMC Jimmy?

The 1993 GMC spark plug wire distributor wire placement diagram can be obtained from most General Motors dealerships. Most auto-parts stores will have the diagram.

What is the wire location on EDI distributor cap on 1995 Chevrolet S-10 Blazer 4.3L?

What wires are you looking for?

Placement of the number one plug wire 88 Chevy 350?

check out this link

What would cause a miss fire on one side of a 4.3 vortec on a 2001 Chevy s10 blazer?

A bad fuel injector poppet, a bad spark plug, a bad spark plug wire, a bad distributor cap and rotor.

Where is the number 1 terminal on the distributor cap for a 2000 Chevy blazer?

Look close, the original cap or a good replacement cap is marked as to which wire goes where. The number one on that flat type cap is the middle one on the drivers side.

Where do you attach the wire to add a tach to your 93 Chevy S10 Blazer 4.3 V6?

The ground wire of the coil. Its the white wire with a black stripe.

How do you wire a 1979 Chevy 350 hei distributor?

You need to run a switched, full-voltage wire to the "bat" terminal.

What is the spark plug wiring order from the plugs to the distributor on a 1998 Honda Civic 1.5l?

What is the proper spark plug wire placement routing to the distributor for a 1994 Honda civic cx

Window on 88 Chevy blazer will not go down?

A blown fuse could be the reason the window will not go down on your 1988 Chevy Blazer. Another possibility is that the switch is worn out or has a loose, broken, or corroded wire.

How do you hookup a tach on a 292 Chevy?

negative side of coil, or if electronic distributor it will have a port on the distributor, then its power wire and ground and then same for lights

How2 hook up sun super tach 2 to a 88 k5 blazer?

u have to look at ur distributor if it is an HEI "coil on top there is markings on the distributor cap for the tach but if it is a regular distributor with an external coil you hook it up to the neg wire off the coil neg/ black wire

Where is the tack wire under the hood of a 92 full size blazer?

Look at distributor it's marked tack at a connection at the side of it