Serpentine Belts
Chrysler LeBaron
Ford Expedition XLT

Do you have the drive belt configuration?


Top Answer
User Avatar
Wiki User
2015-07-15 21:28:44
2015-07-15 21:28:44

If you have the 3.0 v6, the drive belt configuration is actually printed on a plastic cover just below the top radiator hose and distributor. However, if it's faded or unable to read, just make a diagram of all the pulley's and the way the belt is routed (provided the belt is still on the vehicle). You will need to loosen the belt tensioner to remove and install a new serpentine belt which is the only belt you'll need except for the air conditioner. This is a separate v-belt that will need to be removed first.


Related Questions

The 454 cubic inch General Motors engine drive belt configuration can be found at most General Motors dealerships. Most auto-parts stores will give you the configuration when you purchase the belt.

hi there. on the underside of your bonnet there should be a diagram of the belt configuration and how to install the belt. do you have a manufacturers manual in the glove box?

Accessory drive belt.Accessory drive belt.

alternator drive belt?

The serpentine belt would be the same as the accessory drive belt.

NO. Drive belts drive the AC, Power Steering, Alternator, Waterpump, exe. Cam belt=timing belt.

Hard Drive configuration is used to define the Slave and master Hard Drive. When we are attaching more than one hard drive the configuration is used. Configuration is done by jumper setting which is available in back side of hard drive...1st two pins for master hard drive and last pins are slave..

Loosen the tensioner pulley. Remove the old drive belt. Install the new drive belt. Tighten the new drive belt with the tensioner pulley.

how to change the drive belt

Not if you have a serpentine drive belt............

Loosen the drive belt tensioner pulley. Remove the drive belt. Put the new drive belt on the pulley. Tighten the tensioner pulley.

drive belt for what on this vehicle? do u mean serpentine belt,or fan belt,or timing belt?

Belt drive is quieter, but can be damaged by stones caught between belt and sprocket.

We will need some more details... Is it the drive belt or the belt for the blades?it is the drive belt for Murray lawn mower model 38618x92a

slip ratio is more for flat belt compare to flat belt

The hard drive controllers are SATA, IDE, and EIDE. The hard drive configuration tells the computer what drive controller to use and how to store the information and where to store the information.

No, the serpentine belt is used to drive more than one thing and tension is automatically adjust by way of a spring loaded idler pulley. Normally it will drive the alternator, power steering pump, & A/C compressor. A drive belt normally drives only one thing and tension is manually adjusted. A serpentine belt is wider that a drive belt and is not a V-Belt like a drive belt.

what materials are used to make a drive belt

I have a timing belt leak, can I continue to drive

Please give the example of what incorrect configuration you had in mind. My second question is why would you use an Incorrect Configuration in the first place?

In a Windows operating system, an incorrect drive configuration usually indicates a physical error. The error could be part of the drive itself or in the actual mechanism.

A Drive Belt is used to drive accessories installed on a car engine, such as an alternator, water pump, power steering pump, air conditioner compressor, etc. Sometimes a serpentine belt could also be called a "drive belt" or "accessories belt". Some cars have a single serpentine belt running all the accessories, other cars may have two or more drive belts.

a belt drive is a rubber belt that spins around.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.