The bolts aren't easy to get to also you have to remove the exhaust to get the starter out.
The other option is one that I used:
I disassembled the old starter to get it out as well as the new one to get it in. I then reassembled the new one in the space and bolted it on. This is not an easy task and took me over 6 hours to complete. If you are not mechanically inclined, I don't recommend this. But it will save you from having to remove the exhaust. The only thing you will need to remove is the small aluminum plate held on by two bolts that protects the wire harness. You might also need to remove the heat sink from around the exhaustmanifold, but it can be put back on with those metal screw straps.
No I changed my starter in the Walmart parking lot with just a few tools and a flashlight. very easy to do just try to make sure the tucks not hot when doing it.
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
It depends, do you have an inline-4 cylinder 2.2L engine or the V-6 3.2L engine?
Look at the lower rear end of the engine
How to remove the starter from a 1997 Isuzu Rodeo 4X4 automatic
mounted on the starter body
Starter is on passenger side of motor underneath intake bolted to trans bellhousing.
will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission
Where can I print a engine/timing diagram for a 1999 2.2 Isuzu rodeo?
its built into the starter
Yes, but you don't want the 2001 engine, it has more issues than the 1999 engine.
How much oil do I put in a 1996 Isuzu rodeo
how to change engine block sensor
how do you reset a fuel pump on 2004 Rodeo Isuza when it is wreck
cylinder one on a 2002 isuzu rodeo 3.2 engine is on center drivers side
yes they were made with the same engine
What are the torque specs for the rod and main bearings for a1999 isuzu rodeo 2.2. engine
If you're lying underneath your Rodeo with your feet facing the front of the vehicle, the starter should be to the left hand side of the engine, just past the oil plug. If you imagine yourself sitting in the driver's seat, the starter will be right underneath where your right foot is.
The EGR valve on a 95 Isuzu Rodeo is located on the back top of the engine. It resembles a cylinder.
how do you change the serpentine belt on a 2001 Rodeo
remove the starter bolts your 12v power supply and ignition wire then remove exhaust bolts from manifold a few twist and turns and out she comes
The freezer plug in a 3.2 Isuzu Rodeo is a easy find. The freezer plug is located on the left side of the engine.
on the right side of the engine
According to the Gates website ( they make timing belts etcetera ) YES The 2.2 litre four cylinder engine in a 2002 Isuzu Rodeo ( which has a timing BELT ) IS AN INTERFERENCE ENGINE