This may sound bad but it really is this easy. Find O2 sensor (there are two or three and some have four) that you need to change Unplug from wiring Remove using wrench or special socket if you have the special socket Screw in new gently! Plug in.
no a Philips screw driver and a 10mm socket
yes there is a special socket with little prongs on it i dont have tool/part number on hand its at work
10 mill long socket
It requires a special socket with a slot in the side so as not to harm the wiring.
a standard 5/8 deep socket spark plug wrench
It is a special oil pressure sender socket. It is very similar to a 1 1/16 deep well
That requires a special socket made just for oil sending units. Your local auto parts store can sell you one.
YOU NEED A SPECIAL SOCKET TO REMOVE IT And INSTALL IT WITHOUT DAMAGE.IT IS LOCATED ON THE EXAUST MANIFOLD
unplug and unscrew it with special sensor socket... keep in mind most likely it will be seized...
Because the impact will crack an average socket.
It will require a special slotted socket that can only be used for the one purpose. The cost does not justify the means.
no special tools required except a plug wrench most socket sets have plug sized sockets in them
Buy a new oil sending unit and the socket that fits it. The auto parts store should carry both. It's a special socket.
2d from eng. same side as no 1 piston-just check your firing order, buy it on ebay and the special socket to change socket-good luck
In order to change the front shocks, you will need a ratchet and socket kit. You will also need some replacement shock absorbers.
Snap-on socket # SLEPL 200
you will need a special 02 socket for the one in the manifold and you can use a 7/8 wrench on the one after the converter.
You fit a screwdriver bit in a 1/4 socket.
Snap On makes a special tool just for this engine im a diesel mechanic and i have a blazer so i asked him and he showed me the socket it was 8 buks and it worked like a charm no flex joints no long extentions just a rachet and the special socket and its a breeeze
The Cigarette lighter socket needs replaced. Is this an easy task? Also , can the new socket be just a standard or special socket for the Mercedes? Thanks. Ed
you need a special 18mm socket wth very thin walls. i got mine from pitposse.com, it cost $20.