Mercury Cougar
Timing Belts and Chains

Do you need to change the timing belt on a 1999 Mercury Cougar V6?


Top Answer
User Avatar
Wiki User
2011-09-01 13:46:41
2011-09-01 13:46:41

The 2.5 liter " Duratec " V6 engine used in a 1999 Mercury Cougar uses ( 2 )

timing CHAINS , both located at the front of the engine ( 1 chain to each

cylinder head )

User Avatar

Related Questions

The 2.5 litre V6 engine in a 1999 Mercury Cougar has ( 1 timing CHAIN to each cylinder head , so there are 2 timing CHAINS )

Timing Chains (2) with respective guides, tensioners and sprockets.

do u set the timing marks at btdc or tdc on a 2.5 mercury cougar

how do you remove the headliner from a 1999 mercury cougar

No , not according to the Gates website ( they make timing belts etcetera ) The 2.0 liter four cylinder engine in a 1999 Mercury Cougar is NOT AN INTERFERENCE ENGINE

According to the Gates website ( they make timing belts etcetera ) for the 2.0 litre four cylinder engine in a 1999 Mercury Cougar : ( No , it is NOT an interference engine )

Yes , the 1999 Mercury Cougar is FRONT wheel drive

It's a bit buried. Note that the 1999 Mercury Cougar has no user-servicable barts.

mmm there are only 2 engines that came with the car. 2.0 zetec - timing belt interval 90k-100k 2.5 duratec- timing chain and if you upgraded 3.0 timing belt go to and search there is a how to there

relay R1 is for the fuel pump on a 1999 Mercury Cougar

According to the 1999 Mercury Cougar Owner Guide : ( 58.5 litres / 15.4 U.S. gallons )

The 1999 Mercury Cougar OBD 2 port is under driver side dash left of steering column

According to the 1999 Mercury Cougar Owner Guide the six disc CD changer ( if equipped ) is located in the luggage compartment

I was looking at the 1999 Mercury Cougar Owner Guide and it does not show that it has a gas cap warning light

None. Engine timing is set by the PCM, you can not change it with a timing light.

Ebay,, or just drive to your ford/mercury dealer.

The engine diagram for a 1999 Mercury Cougar is used in diagnosing and repairing problems. It gives the location of each component and its connection type.

how to remove the door panel on a 1992 mercury cougar

On a 1999 Mercury Cougar : The ELECTRIC fuel pump is INSIDE the fuel tank It is installed through an access hole in the top of the fuel tank

The door lock, on your 1999 Mercury cougar, can be replaced by removing the inside door panel. The locking mechanism is easily visible and can be changed.

Remove the tire and wheel from your 1999 Mercury Cougar. Remove the axle end. Remove the wheel bearing retaining nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.

It's grounded on the front of the Mercury Cougar frame next to the headlight assembly.

You can view the 1999 Mercury Cougar owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides

firewall 1-----2-----3 ( bank 1 ) 4-----5-----6 ( bank 2 ) front of 1999 Mercury Cougar ( V6 )

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.