Often on full sized pickups, there will be enough clearance below the oil pan to remove it without lifting the engine. sometimes a crossmember or other object may be too close, but would be easier to remove than lifting the engine. If one has to lift the engine and has no hoist, one can often undue the motor mounts, put a block of wood under the pan, such as a 2x6 about a foot long to spread the weight, and lift the engine with a floor jack. Carefully blocking the mounts to rest the engine back upon should give enough height to remove the pan. Reverse the order on installation.
5 quarts ( 4.7 liters ) with filter change
On a 1992 Ford Thunderbird : ( both the 3.8 liter V6 engine and the 5.0 liter V8 engine have a timing CHAIN )
replacement lamps comes with faq sheet with pictures on how to.
Where are the timing marks on a 1992 Toyota Paseo 16 efi 1.5 liter engine?
Yes!
4.3 liter
5 quarts / 4.7 liters , with engine oil filter change
On your 1992 Ford Ranger , 4.0 liter : The starter should be on the drivers side of the engine , low down , where the transmission bolts to the rear of the engine
its a 350hp vortec engine.
For a 1.8 Liter engine 0.028 to 0.035 inch. A 2.0 Liter engine 0.024 inch is the gap.
You could have the 2.3 liter four cylinder , the 3.0 liter V6 , or the 4.0 liter V6
You could have the 2.9 liter , the 3.0 liter " Vulcan " or the 4.0 liter V6 engine . They are all over head valve / pushrod designs in a 1992 Ford Ranger