They are 2 different part numbers, so I wouldn't attempt trying to make it work.
No because the suspensions are completely different
If your vehicle has a sway bar it has sway bar links. There would be two links per sway bar, be it front or rear.
Ensure all sway bar links are good (front & rear). Make sure front end is tight and struts are not worn.
Front is torsion bar and rear is leaf spring. Both front and rear have anti-sway bars http://en.wikipedia.org/wiki/RPO_ZR2
It has a sway bar in the front and in the rear. It has a connecting link at each end of each sway bar = 4 total
there should be a rear sway bar
The Envoy comes with front and rear swaybars from the factory. They work better after you replace the bushings with some greasable polyurethane ones. www.trailvoy.com
I have a 2000 Buick Regal GS how do I change my front sway bar
go to e-bay and look for corolla suspension parts, jdm and other aftermarket suppliers offer hd sway bar, stouter sway bar links, bearings, arms, front / rear or both..
how do you replace the front sway bar likn in a 1999 Grand Marquis?
to do the frt one's put a jack under the sub frame and then undo the sway bar links remove the two rear sub frame bolts and let the jack down slowly you may have to unhook the exhaust at the flex pipe remove the four bolts from the sway bar bushings and the bar should come out.
sway bar end linksway bar end link
If it has more than 100k miles, it probably needs new struts. Other possibilties are broken sway bar, worn sway bar bushings, or softer tires (like BFG Radial T/A). Check the anti-sway bars at the front and rear. You could have a broken sway bar linkage, which is easy and cheap to fix. The car will usually make a clunking sound if you have a broken linkage when you turn sharply.
Low air pressure in one or both rear tires, a sway bar or sway bar link is broken.
Need to know what your question is.
go figure it out or get a life
I am guessing the rear anti-sway bar? Spoiler
How do you install a rear sway bar on a 2003 f 150 4 wheel drive
No but it should torsion/ swivel >Either a front or rear sway bar shouldn't have "play" in it. Not any noticeable play anyway. If you have it up on jack stands it may have additional play but nothing extreme. Check that the rubber endlinks or bushings are present and in working order.
change the sway bar rubber bushings and sway bar link bushings
Check with a Ford dealer - there was a recall on the front sway bar links because under certain conditions they could fracture - so they were replacing the left and right front sway bar links under the recall. (Helpfull)
p That would be by having 5 leaf leaf springs in the rear from the 4 that came in some depending on the engine option, also some did come with a heavy duty sway bar in the rear that can be purchased from mustangsunlimited.com. also installing a heavier duty front sway bar is a big improvement especially for the mach1s that have the 429 V8
Since The Villager is of unibody construction, there are only a couple things that can be considered "subframe bushings". Sway bar bushings (front and rear), rear leaf spring bushings, and the most likely, control arm bushings.
check sway bar it is a long bar in the rear that goes from side to side Cheeck bolts where it attaches many times these bolts are loose or broken
Sounds to me like you are talking about the rear sway bar.
It may be your shock absorbers or the front sway bar.