The 1989 Nissan Stanza 2.0 4 cylinder has a timing belt. This is also an Interferance Engine, and as such if the belt breaks, serious engine damage will occur. The belt should be replaced at 60,000 miles.
In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT
ca20? remove all the belts, water pump pulley, underdrive pulley, timing chain cover and timing belt and the water pump is accessible. I would replace the timing belt too.
You don't. 89 sentra does not have a timing belt, instead it has timing chain. I have the 1989 Nissan Sentra 1.6L 4-dr sedan. My timing chain needs to be replaced. It runs inside the motor. It is a big task for an auto mechanic to replace it. It will cost me at a *trustworthy* business $470 for part(s) and labor to replace it. Expect it to take a whole day for the car to be in the shop.
How to Set timing on nissan sentra 1600cc 1989 model
A 1989 Honda Accord has a timing belt.
TIMING BELT for the 2.7 liter V6 engine in a 1989 Acura Legend
how much play should a 4.3 Chevy engine timing chain have?
In a 1989 Mercury Sable : Both the 3.0 and the 3.8 litre V6 engines have a timing CHAIN
chain, to the best of my knowledge belts were never used on the 3800.
On a 1.6 litre, it's 7 degrees btdc.
According to the Gates website ( they make timing belts etcetera ) The 3.0 liter V6 engine in a 1989 Ford Taurus SHO has a timing BELT
No, it has a timing belt which must be changed every 60,000 miles.
I would suspect you need a new timing chain or belt depending on which is installed. A worn belt or chain will jump time.
most likely a belt, mine has the belt
it is 12 atdc for the 88, I assume they are the same
my head gasket was blown and it had water in the oil which made the oil look a milky color
look at your engine oil you may have a leaking head gasket
Normally an engine this old that needs a new timing chain, also needs an overhaul. I cannot tell you in this limited space how to change the chain and gears. I suggest you purchase a Haynes, or Chilton's repair manual.
It is a big job. Get a manual from the parts store or from AUTOBOOKSONLINE.COM with your hands
Yes it should be on the far right of the engine
The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.
You have to take the front of the engine off to get to it. Pain in the butt.
The is none to check.Cam drive is by chain located under the valve cover and in the timing chest.