Yes it does. And it should be replaced, because most people do not replace them ever in the 3.1 engine. It is located underneath the far valve cover( not the one right in front, it's towards the back of the engine.) You may have to take off the upper intake to get to it.
Add your answer:
Related Questions
How fast can a 1993 Chevy Corsica go before the governor kicks in?
A 1993 Chevy Corsica can only reach 111 MPH before the factory governor will be applied....this is with the 2.2 Liter engine
Did not find trunk release button on 1993 Chevy Corsica?
where is the trunk release button for 1993 chevy corsica
Will a transmission from a 1993 Chevy Corsica fit a 1996 Chevy Corsica?
Ask the same question at batauto.com in the forum for transmissions. Koug
How do you remove headrest from 1993 Chevrolet Corsica?
how to remove headrest of 95 chevy corsica without tabs
Where is the fuel pump relay switch on a 1993 Chevy Corsica?
in the trunk
Where is the sensor for the oil and temperature gauges on a 1993 Chevy corsica?
where are the senders on a 1993 Chevy corica for the oil and temputer gages to reinstall
Where is the oil filter on a 1993 3.1 v6 Chevy Corsica?
It is screwed onto the engine near the bottom on the LH side. The LH side of the engine is the side near the radiator.
How do you replace the front strut motor mount on a 1993 Chevy Corsica 3.1 engine?
It is as simple as removong 2 bolts and replacing the mount. Goodluck, JOe
How do you install a starter on a 1993 Chevy Corsica?
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Does the computer have to be reset after disconnecting the battery on a 1993 Corsica with a 3.1 engine?
NO
Where is the egr valve on a 1993 Chevy K1500?
Assuming V8 gasoline engine, it should be bolted onto the intake manifold.
What is the problem with a 1993 Chevy Corsica that will not stay running?
Try changing the fuel filter.
Location of ignition module for 1993 Chevy Corsica?
The ignition modual is in the front of the engine compartment, below the front manafold between the motor and the radiator above the starter
1993 Chevy corsica which the abs modulator valve was replaced now the abs unit just clicks and will not work how do you reinstall the abs motor pack to the abs modulator valve?
thats easy you just ....... get a life thats easy you just ....... get a life
Why would both headlights suddenly go out on a 1993 Chevy Corsica?
Check the Fuse and/ or relay.
What is the firing order for a 1993 Chevy Corsica v6?
1-2-3-4-5-6
Why would the plug gap on a 1993 Chevy Corsica be 060?
Because it has HEI (High Energy Ignition).
Where is the EGR valve on a 1993 Pontiac 23?
As I recall, that engine does not have an EGR valve.
Where is the knock sensor for a 93 cavalier located?
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
1993 Chevy Corsica 3.1 engine radiator fan don't work what to do?
Try wireing it straight to the battery and see if it turns on. If it dont turn on then your motor for your fans is bad and needs to be replaced.
How do you replace a melted tail light wire without removing the dashboard on a 93 Chevy corsica?
the wire is bare how do you replace the wire with out removing the dashboard on a 1993 Chevrolet corsica?
Where is the PCV valve on a 1993 Chevy Beretta?
on the back side of motor by firewall
Where is the horn valve located for 1993 Chevy blazer s10 4wd?
Horn valve? Please give more info.
What causes the temperature gauge to quit working on 1993 Chevy Corsica?
bad temp sender usually. Bad gauge rarely.
What is the torque pressure of 1993 Chevy truck?
That depends on what engine it has.
