at the top hose from rad. at engine
The 1997 VW heater hose has swivel nuts on each end of the hose. Turn the swivel nuts to the left to remove the heater hose.
It is a heater hose.
Should be in a removable housing at the engine end of the upper radiator hose
The heater hose on a 1997 Ford Escort has got both the length and radius. The length is 417 millimeters while the radius is 50 millimeters.
At the top end of the lower radiator hose within the water outlet. I hope this helps you. Rob
Its on the driver side firewall connected between the heater hose. Its a metal valve with heater hose on both sides and a lever on top that connects to the temperature adjustment switch on the dashboard.
Usually you just buy hose and bypass the core.
Heater CORE, not coil. The core is plugged and needs back flushing or replacement.
On the firewall above the air intake hose and the purge canister. You can't miss it.
1. Undo the Hose clamps by the engine and the firewall . 2. remonve hose . 3.Put on new hose . 4.tighten .
if it has one it is in heater hose at firewall if it has one it is in heater hose at firewall
Haynes Auto manual from Auto Zone for about 20 bucks.Toyo joe
You know the heater hose on a vehicle needs replacing when it beings to swell and soften. The heater hose runs from the intake manifold to the heater core.
take off clamps, take of hose, and take of your mom!
Heater hose or heater core.
How to replace a heater hose on a 2001 Oldsmobile silloute
Just take one of the heater hoses loose at the heater core and loop it back to the motor to the other heater hose. Or you can take them both loose at the heater core and put a splice connector between them is this is easier.
In the engine bay, remove the inlet and outlet hose from the firewall for the heater core, get a heater hose connector that matches the hose sizes (fair warning they are 2 different sizes but i cant remember) and just join the 2 hoses together with the connector and some clamps. you wont have heat or defrost by doing this though.
The Chevy heater hose removal tool is a plastic piece that clamps around the hose. The tool slides into the fitting to release the hose.
On a 2003 Bonneville, the hose to the water pump that is the heater inlet hose is the top hose coming from the radiator. This is also the hose that holds the thermostat.
I don't know which engine you have so I can only tell you that on my Dad's 84 the thermostat was behind the inlet for the BOTTOM hose instead of the top hose. It is located below the distributor cap on the driver's side of the engine.
one large hose from bottom of radiator to side of water pump. other large hose from thermostat housing to top of radiator. one heater hose from water pump to heater core, I think this one has a Y in it if there is a rear heater other heater hose from heater core to somewhere on top the engine. If there is a rear heater, its return hose goes to a fitting on the radiator.
If it's the one in the engine bay you talking about, there is one that connects to the heater tap on joint to the heater hose.
The heater inlet hose on a Hyundai Accent is in the back of the engine compartment. It goes through the firewall to the heater core.