Best Answer

There are a wheel bearings in the hub in the front of a 2000 neon. It is generally not a problem and is maintenance free. In other words, you do not grease them; the seal is maintenance-free.

they are called a hub brg. assembly. yes they are sealed. if your replacing, you replace the assembly(inner and outer brgs together) if u r driving down the road and hear a roaring noise from the frt. steer fairly hard to right then left to determan which one is the problem. if noise gets louder when u turn right this means the left brg. is bad. what?????. yes, when u turn right the weight of the vehicle is shifted to the left putting more weight(stress) on that brg. good luck master tech 26yrs

User Avatar

Wiki User

โˆ™ 2011-01-06 23:53:35
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does a 2000 neon have front wheel bearings?
Write your answer...
Related questions

How do you change the front wheel bearings on a 1998 Plymouth Neon?

You will need to take the front spindle off and take it to a shop that can press your old bearings off and new ones on.

Is a 2001 dodge neon a front wheel drive or back wheel drive?

Front wheel drive.

Where is the horn on a 2000 Plymouth Neon?

The horn on a 2000 Plymouth Neon is located at the front of the engine compartment near the headlights. It is trigger through a press of the steering wheel like most other vehicles.

Is a 1996 dodge neon front or rear wheel drive?

all neons are front wheel drive!

Is the 2002 Plymouth neon front wheel drive?

All Neon's were front wheel drive. Whether it be the Dodge or Plymouth.

Wheel bolt pattern for 2000 dodge neon?


Is a 2004 dodge neon a front wheel drive vehicle?


Do engine mounts hum when worn out i have 2001 neon and i'v done both front wheel bearings and tie rod and cv's and got alinement. how can i fit the humming?

Are you sure it is not just tire hum?

Is Chevy hhr front wheel or rear wheel drive?

Was just looking at at 2009 and it was front wheel but am hoping the SS is all wheel or rear even. Its is definitely a truck underneath not like the pt cruiser which is a neon.

What is the torque specs 2000 dodge neon rear wheel assembly?

160 foot pounds

How do you replace front wheel lug bolts on 2000 neon?

Beat the old ones out with a hammer, push the new ones in the same way as far as you can, then zip them in all the way with the lug and an impact.

Where is the pcm in a 2000 neon?

under hood front to the left of the radiator (on drivers side)

Water coming in 2000 Dodge Neon front floor?

Heater Core is the likely culprit

How do you remove the front bumper on your 2001 Dodge Neon SE?

Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036

Will a 2001 dodge neon motor work in a 2000 neon?

no a 2001 dodge neon motor will not work in a 2000 neon

Where is the turn signal flasher on a 2000 Plymouth Neon?

Connected to the multifunction switch, underneath the upper steering wheel cover.

Were is the purge solenoid at on a 1998 neon?

It is located in the cavity behind the passenger side front side marker light between the front bumper and inner wheel well.

Can you repack 2001 dodge neon rear bearings?

No, they are a sealed unit.

How do you replace the front wheel bearings on a 2000 Plymouth Neon?

Pull the wheels, pull the brake calipers, remove brake disc. Next you will have to disconnect the lower ball joint and outer tie rod end. Remove keeper key and cover to access the large nut in the center of the hub. Remove the hub nut. Remove the two large nuts and bolts from the bottom of the strut where they attach to wheel "knuckle." Slide wheel knuck out toward you and the axle should slide out of the back of the hub. Now that the knuckle assembly is completely removed from the car, take it to a machine shop and have the old bearings pressed out and the new ones pressed in. Reinstall in vehicle and you are done.

What is the proper way to tow a front wheel drive dodge neon?

There are two approved towing methods. One, all four tires on a trailer or tow truck. Two, front tires on a tow dolly or wheel lift.

How do you charge the air conditioner on a 2000 neon?

how do you charge the air conditioner on a 2000 neon

Is a 2000 neon OBD or OBDII?

The 2000 Dodge Neon is a OBD 2 port

Signs of bad rear wheel bearings on 2005 dodge neon sxt?

My car currently has bad rear wheel bearings, the car shakes at 50-55mph and if you tilt your side mirror down to look at the wheel while you are driving, you'll see it wobble.. you can also pull on it while its parked and it will squeek and rock back and forth. Its highly dangerous so dont hesitate to get it replaced right away

Will a bodykit for a 1999 Dodge Neon fit a 2000 Dodge Neon?

No it will not the 2000 neon was a totally new design for the body and it won't line up correctly you need a bodykit for a 2000-2003 neon to fit best.

What would cause a constant roarng Noise from rear of 2003 neon front wheel drive?

it might be your drive shaft or transmission going out.