Crankshafts are usually always forged for strength. Connecting Rods and pistons are usually always cast in normal consumer vehicles. Race and High Performance vehicles have very exacting designs and are usually built differently.
where is the ground wire on a 2006 chevy cobalt 2.2 ecotec motor
Theoretically, yes.
yes
My RV Chevy engine V8 454 has 43000 miles , til now inewer had a problem, my last trip was a horror, after 50miles the engine begin to cought and misfiring on the muffler, and it was not running round
The 1997 Chevy crankshaft sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
It should have a 2.2L L4 engine.
No
No it will not
If the 8th digit in each vehicle's VIN are the same... then yes!
how many quarts of oil does a 2009 Chevy cobalt need with a 2.o engine?
4
yes when the engine is out and upside down
Depending on what the engine was used for, most likely dish top pistons. But flat tops ARE possible.
5 quarts
The transmission dipstick, On a 2008 Chevy cobalt, can be found at the back of the engine compartment, near the center. The dipstick handle will be bright yellow.
It is a high performance 396 Chevy engine. It had 375hp, Holley 800, Mechanical Cam / Lifters (500 lift, 316 Duration), Square Port Heads, 11:1 Compression, 4 Bolt Mains, Forged Tuftrided Crank, Forged Pistons, 4.126 x 3.76 Bore & Stroke.
No, the engines are completely different.