Want this question answered?
You put a new crank sensor in your 92 buick and now its like its out of time?
New crank shaft or new crankshaft position sensor? If not crank sensor then replce it If new crankshaft probably the wrong one for the year and the notches are off...need more info
no no no my crank sensor when out on my truck ar 95k now i have 125k and she is still running good
your crank sensor has absolutly nothing to do with the ability of the engine turning over. I would look at the wiring to the starter.
if your crank position sensor is bad you car or truck will not start because you will not have spark
its junk! crush it!
The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.
The crank sensor on a 4.3 Blazer is located at the front of the engine, under the crank shaft pulley. To replace it, remove the wire plug and the 8mm bolt holding it to the timing cover. Clean the area up before installing the new sensor, lubricate the )-ring on the new sensor with motor oli before installing it. Snug up the bolt and replace the wire connector.
Many other options. No fuel pressure, broken timing belt, computer malfunction, no spark,
It is on the passenger side of the transmission bell housing.
The crank shaft sensor is on the bell housing of the trans, buy a new one and look for the plug end that looks alike. also if u are looking for the cam positioning sensor it is on the left side of the engine coming out of the valve cover.
About $21.99 at autozone.