Ford Taurus
Mazda Protege
Ford Explorer XLS

Does a Protege 2000 have a speed sensor if not equipped with cruise control and where is it?

272829

Top Answer
User Avatar
Wiki User
Answered
2006-11-29 22:06:13
2006-11-29 22:06:13

Is it locate on the transmission, it is a 2 wire cable.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A malfunction in the range sensor could cause the cruise to be inoperative.A malfunction in the range sensor could cause the cruise to be inoperative.

Yes it could, if it is setting codes it will affect the cruise.

If the suburban is equipped with the 4l60E automatic transmission then the throttle position sensor acts electronically as a "kickdown cable". The only cables on the throttle should be for the accelerator pedal and cruise control, if equipped.

If the cruise control will not engage, there might be a problem with the Electronic Fuel Injector or the MAP Sensor. There might also be a problem with the Oxygen Sensor. Some autos have more than one oxygen sensor.

How to know if air sensor not working on protege 2003

check to see if your spoiler brake light is out replace it and it usually will finish the ground to the abs sensor and cruise control

The speed sensor tells how fast the wheels are turning. The cruise control uses this to maintain the speed. When you get the code for speed sensor it is not working properly.

depending on the year of the car it could be as simple as a leaking vacuum line or in newer models a bad sensor located on the motor that controls the cruise control

Blown fuseA short in the cruise control circuit,Faulty brake or clutch switch,Leaking vacuum circuit,Faulty cruise switch,faulty stepper motor,faulty transducer,faulty speed sensor,faulty cruise control module.That help a little?

Check the pressure sensor on the master cylinder - very common.

If the cruise control is not working on a 1993 Villager GS with 199,000 miles, the problem could be the MAP sensor. It could also be an oxygen sensor that is bad. There is also a possibility that the unit's main fuse is blown.

If a 1985 Ford F150 5.8, with a replaced speed sensor, cruise control surges and with a working pedal switch, it is due to vacuum leak. Check on the cruise box under the hood for any leaks.

The engine computer is not getting a road speed sensor reading.

If it has one, it will be located in the tail stock on the left side of the transmission. If your speedo is broken, usually it is the cable that has failed. And, if it has cruise control, the section from the cruise control to the dash would be bad.

The cruise control relay is in the engine compartment on a 1994 Escort LX 1.9L. It is part of a bank of relay switches near the battery. The cruise control is also controlled by the electronic speed sensor on the throttle body (carburetor).

The fuse for the cruise control on a 1998 Nissan Sentra is at the Number 22 spot in the fuse box. This is a 10 Amp. fuse that also controls the horn and steering switch. if the horn still works, check the speed sensor on the transmission or the cruise control module on the carburetor.

No cruise control or fender mounted brake lights on a 2002 Tahoe could mean a short in the wiring or the ground wire has failed. No cruise control is also a result of a bad oxygen sensor. Most GM made vehicles have two oxygen sensors.

There are several things that can cause your 2003 Dodge Ram cruise control not to work. The most common cause is a blown fuse. A malfunctioning speed sensor can also cause the problem.

need to know what wire go were for a 94 Mazda protege MAF sensor

You could check the switch on the brake pedal, sometimes they need to be adjusted so the cruise will stay on.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.