For your 1992 Nissan/Datsun 300ZX: Flywheel Torque 61-69 Foot pounds (Final torque)
To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.
On my 93 the thermostat is behind the water pump. If you remove the waterpump you will see the thermostat.
In the thermostat housing on the front of the engine were the radiator hose attaches
When changing the thermostat on a Nissan 300zx first drain the coolant from the engine. Then find the lower coolant hose on the radiator. Trace the hose to the thermostat housing. Remove the housing to uncover the thermostat and replace the unit with a new thermostat.
200HP 227lb ft torque.
Flywheel Torque 61-69 Foot pounds
You'll have to take off the water pump because that is where the thermostat is.
It is best to remove the torque converter to change a gear box on a Nissan. This will help there to be a smoother time adjusting the gear box.
look up 300zx manual on net it has all specs.
should eather be at the top in to engine or on bottom hose coming from engine
the main hose coming off the top of the radiator were it goes int0 the engine.
no power to starter on Nissan 300zx twin turbo
There were 3,000 Nissan 300zx convertibles made
VG30DETT is in the 90-95 Nissan 300zx. It is a v6
Yes it will
its right in front of the motor one of the silver pipes... take out the rad and then take the fan off for good acsess... then pull the thermostat off.
Don't know but if anyone knows where the flasher unit is located on a 1980 nissan 280zx, i'm interested..
If they both have the same engine.
replace coil springs in a nissan 300zx
Where is the ignition control module on a 1987 nissan 300zx
i have a 300zx Nissan and i need to replace themultifunction switch i don't know how?