Remove tank, remove sending unit, replace pump, replace tank.
Refer to repair manual for proper instructions Remove gas tank remove sending unit replace with new sending unit and properly reinstall sending unit and gas tank
you have to remove the fuel pump it is connected to it, it has to be replace as one unit
Remove the gasoline from the gasoline tank. Remove the fuel line from the gasoline tank. Remove the fuel sending unit retaining plate. Reverse the process to install the new fuel sending unit.
Remove oil sending unit and replace with a mechanical gauge
You will have to replace the fuel module which consists of the pump, sending unit and sock filter. Which means you will have to remove the fuel tank.
The thermostat on a 92 Pajero Diesel is on the left hand side and just above the pump. Remove the old thermostat and replace it with the same size.
To replace glow plugs on a Peugeot 405 turbo diesel, remove the connecting wire. Take off the 8 mm nut, followed by the 10 mm deep socket. Remove the old plugs and replace with new.
you have to remove rear seat ,under the seat there's two covers , one is for the fuel pump , the other is for the fuel gauge sending unit .Remove cover on passenger side and remove fuel gauge sending unit .
If you suspect the sending unit may be faulty just replace it with a new one, they are not expensive but a little difficult to remove and replace.
you have to remove the oil pan and replace the pump
there is an access plate in the trunk. Remove carpet remove and replace. Beware of gas fumes and spillage.
The fuel pump and sending tank are integrated into the tank. Drop the tank to remove and replace it as it is located on the top of it.
drop the fuel tank and remove the fuel pump module.
Lower the Gas tank. Remove the sending unit/fuel pump from the tank and replace the unit. The sending unit and fuel pump come together.
Remove fuel tank Remove fuel pick up and sender assembly.
Use a breaker bar in the belt tensioner to relax tension and then remove/replace belt
Remove wireUnscrew old one and replace
Not knowing what vehicle you have, with most of them you have to remove the fuel tank to gain access to the unit.
I drop the tank.
Cut the rubber seal and gently push the windscreen out.
The engine has to be removed.
Not sure on a 2002. But I changed mine on a 2004. More than likely, the same place. The sending unit is in the fuel tank. This is located under the rear seat. Remove the rear seat (pull tab, 1 on each side, lower front). You will see an access panel. Best to do this job when fuel tank is low. Remove the panel. Remove electrical connection, remove hoses, remove bolts. Fuel pump and sending unit all comes out together. Replace sending unit, re-install unit. Found sending unit on-line (don't remember where) 45. - 50.00 bucks) Mitsubishi dealer wanted 400.00 to replace. Good luck
You have to remove the gas tank, Then remove the sending unit in the top of the tank. That will be were the fuel filter is located.
It is inside the fuel tank, you have to drop the tank, and remove the sending unit, from the tank to replace the fuel pump.