Buick Electra
1995-1999 Dodge & Plymouth Neons
Air Filters and Intake Manifolds
Grand Am SE

Does the 1990 Buick Electra have a PCV valve and if so where is it located?

515253

Top Answer
User Avatar
Wiki User
2015-07-15 18:46:11
2015-07-15 18:46:11

Yes, it is located in the intake manifold behind the throtle body.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Open the drivers door and look at the side of the dashboard. This is your access to the fuse box.

User Avatar

The 1990 Buick LeSabre air conditioner recharge valve can be found on top of the air conditioning compressor. The air conditioner recharge valve will have a blue top.

User Avatar

Officially, in 1990. 1991 renamed the car Park Avenue with a new body style.

User Avatar

Under the alternator. You must remove the alternator to get to it.

User Avatar

where is the PVC valve located on a 1990 ford ranger 2.3 L

User Avatar

There is no egr valve on a 1990 Mazda MPV 6 cylinder

User Avatar

where is the oil plug on my 1990 park avnue

User Avatar

the 2.3 and 2.4 engines dont have a pcv valve,they have an oil/air separator located on the right side of the engine as you look at the engine from the front.it looks like a black box with 3 hoses attached to it.

User Avatar

It should be right on the valve cover somewhere.

User Avatar

The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.

User Avatar

ON MY 3.8 IT WAS A SPARK PLUG WIRE THAT WAS SHORTING TO THE FIRE WALL. HOPE THIS HELPS. PAUL G

User Avatar

The 1990 Plymouth EGR valve is located on the outside of the air cleaner housing. The EGR valve can be found on the back side of the housing.

User Avatar

The fuel pump is located inside the fuel tank.

User Avatar

I believe they are located on the starter.

User Avatar

I have a 5.8L in my 1990 and it is located behind the intake on the passenger side. Right by the valve cover.

User Avatar

... There is no carburetor in a '01 Buick... the last Buick to use a carburetor was in 1990. If you are talking about the throttle body, however, there is a butterfly valve inside, but the only way to get to it is to remove the throttle body.

User Avatar

The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.

User Avatar

under the hood by the transmission

User Avatar

Bleed valve is located on top of thermostat housing.

User Avatar

the 89 with the 360 has the pcv valve in line behind the carburator.

User Avatar

the EGR valve is just under the distributor cap


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.