Asked in Chevy Camaro RS
Chevy Camaro RS
Does the 1991 Camaro RS have a mechanical kickdown or a vacuum advance?
Asked in Cars & Vehicles
How do you set vaccume advance on 350 hci edlebrock 4 barrol camaro 1973?
You will need a timing light with the timing advance option so you can adjust and monitor your changes. Vacuum advance limiters along with mechanical advance timing weights and spring kits are available from after market suppliers. ...
Asked in Volume
Does a 86 caddy 5.0 liter distriberter have vacuum advance?
Yes, it does have vacuum advance.
Ignition timing for 1600 beetle?
I really depends on what distributor you have on the engine. It could be a mechanical advance distributor or a vacuum advance distributor (stock). Google "the Somba" Volkswagen forum and all will be explained. ...
Asked in Pontiac
How do you replace the vacuum advance on a 1970 Pontiac V8?
Remove the distributor cap. Remove the hose to the vacuum advance. Remove the two screws holding the vacuum advance on. Install in reverse order. ...
Asked in Chevy Camaro RS, Chevy Camaro
Where can you find a vacuum diagram for a 94 Camaro?
autozone website i got mine off of there for a 91 camaro
Asked in Ford Thunderbird, Ford Trucks and SUVs
Do you need to unhook your vacuum advance when using the timing light?
YES! Any time you adjust the timing you should disconnect the vacuum advance. ...
Asked in Dodge Dart, Dodge Ram
How do you adjust vacuum advance on a dodge electronic distributor?
pull the hose off the vacuum advance and some of them have a set screw inside the hole. ...
Asked in Chevy Malibu, Chevy Chevelle
1970 Chevelle Malibu with a 350ci engine What should the timing be without the vacuum advance then with vacuum advance and at what RPMs?
800rpm manual transmission, o degrees advance 1200rpm automatic transmission 4 degrees advance ...
Asked in Ford, Ford Falcon
How do you adjust the vacuum advance on a ford 302 distributor?
>you don't adjust the vaccuum advance. you adjust the distributor. then when engine is running the vaccuum advance will work automatically to the needs of the engine< As a matter of fact, the Ford vacuum advance is easily adjustable. Put a 1/8" Allen wrench through the open of the vacuum advance canister where the vacuum hose goes. Screw it in to slow the rate of advance and screw it out to speed it up. I think it works on a spring preload...
Where is the 8 degrees btdc mark for a 305 Chevrolet engine?
Going up the scale from "0" the 4th mark is 8 degrees. Be sure to check the mechanical and vacuum advance as well. ...
Asked in Chevy Lumina
Where is the vacuum advance located on 1992 Chevy Lumina v6?
According to the repair manual that I am reading, you do not have a distributor, you have coil packs (3). There is not a vacuum advance persay. The spark advance is caused by the vehicle computer. ...
Asked in Chevy Silverado
Where is the vacumn advance for a 95 4x4 tk-350 engine?
That engine does not have a vacuum advance.
Where is the timing supposed to be for a 94' Chevy 350 with HEI ignition?
around 6-8 degrees with the vacuum advance blocked off. electronic ignition has no vacuum advance! How does one blank off the electronic advance??? ...
Asked in Chevy 350, Ford Ranger XLT
Does the vacuum advance get constant vacuum or not?
Manifold vacuum usually. There may be some instances where someone reworked a distributor to arrive at a specific timing curve under load using ported vacuum with the vacuum advance, but this would be rare as most people would re-curve their distributor by changing advance weights and springs and would limit the advance built into a distributor so they could use more initial timing without having the total timing go over 36-40 degrees when the engine is revved up and all advance is in. ...
79 Yamaha xs 1100 vacuum lines?
vacuum lines,there are three one for each petcock and one for the vacuum advance, the two for the petcocks go to the carb boots, one on each side,and the one for the vacuum advance goes directly to the no. two carb. ...
Need vacuum schematics for 85 Chevy pickup distributor?
vacuum advance can connect anywhere there is vacuum present,carbuerator base is a good spot ...