No, the engine doesn't have to be pulled to change the water pump.
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
they can probably be changed the way as the 92 by just taking out both of the bolts on the caliper.
You pull the old one out and push a new one in.
13/16 inch
If same engine and transmission model, yes.
The power steering is driven by the serpentine belt which must be changed by releasing the tensioner, located below the alternator. The only other belt is for the A/C compressor.
13/1613/16
You remove them one at a time, and install the new one the same way.
They went from the hide-a-way lights to the molded lens in 1993.
Spend $15 bucks or so for a haynes manual from the local autoparts shop.. your gonna need it.. :)
If its anything like my 88 lebaron convertible on the inside your going to have to take out the trim on the floor by the door and then take off the whole side panel in the back seat...a pain!
should do.. Check the VIN Number, the 1993 and 1994 can be replaced without restriction, but if the production date is earlier, change the newer TCM module, too (even if it works with the older one, but the newer are better and your car will use less petrol