It also means check your oil level, sounds to me like it is down a couple quarts.
what is your ?, a MAF is basicly a IAT The Mazda Protege and Protege 5 2.0L engine has an IAT Sensor located just past the factory air filter box. It is a two wire sensor that plugs into the intake tube via a rubber grommet. The three wire plug in the Mass Air Flow Sensor. DO NOT Unplug either of these sensors while the vehicle is running or key turned to accessory. Will cause a flag in the computer and turn on the Check Engine Light. Hope this helps.
Try warming the car by letting it run for a short time, but not letting it get hot. Also something like WD40 sprayed down in there overnight will help. Never Use WD40 unless you are absolutely sure the sensor is U/S. The silicon in wd40 will adversely affect the O2 sensor operation.
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
It means there is bad/no connection between the car's computer and the oxygen sensor after the catalytic converter.
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
How to know if air sensor not working on protege 2003
You would need to diagnose the problem to determine why the cam sensor is failing. It could be a mechanical problem and they are breaking or an electrical problem and burning out.
no sensor only a thermostat
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
On air box right befor maf sensor
need to know what wire go were for a 94 Mazda protege MAF sensor
It is the top one
that is the cooling fan relay.
this problem could be your mass air sensor, or the problem i had when this happened to me was the catalytic converter is breaking apart on the insid clogging your exhaust.
you can't fix a sensor, you can replace one by removing it and installing the new one...:)
you needs a dpfe sensor
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt