answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2009-10-27 14:44:00

-Chromium plating is commonly used as it protects brass and copper fittings which are exposed to water from becoming covered in verdigris. -

Correction- it USED to be chromium but then they found that silicon works better.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions




Copper is suited for pipes, but not for moulding into faucets as it's not strong. All faucets are steel, with a chrome coating.


That water is used in the cold taps in your bathroom and for the heated water you use. Don't drink from these taps.


The earliest water taps were invented by the ancient Egyptians and Greeks.


The four national taps are the Local Catchment water, Imported water, NEWater and Desalinated water.


Not all plumbing devices do; some have combined hot/cold taps. In either case, hot and cold water lines are separate, the hot water coming from a water heater. The simplest taps merely control each line, letting the user measure out how much of each they want.


Taps need not be made with metal.... But most taps are because they don't melt if hot water passes through............


Singapore's 4 national taps Singapore's 4 national taps are:1) Water from local catchment2) Imported water from Johor3) Desalinated water from the sea4) Reclaimed/Recycled water from local waste water (NEWater)


Check the upstairs taps for blockage in aerator or internally.


You probably have a poorly insulated section of pipe. It must be between the taps and the hot water source.


The four national taps are the Local Catchment water, Imported water, NEWater and Desalinated water.


The four national taps have been able to provide a low-cost, reliable and long term solution to the water crisis in Singapore. The four taps are: local catchments, desalinated water, imported water and ne-water.


Underground/Above ground pipes from the water station


Usually there are no letters on French taps; some old taps bear the letters C (for chaud = hot) and F (froid = cold). Hot water taps are always located on the left side, cold water taps on the right. It is also standard to find color marks (blue for cold, red for hot) on the taps. On newer models, having a central lever instead of two taps, you turn the lever to the left for hot water and to the right for more cold water. Also the blue and red marks may be found on these type of taps.


by turning the taps of when your not using it


Very easy once the supply lines to both the hot and cold water supply are shut and then work can proceed on changing out the "taps"


They have a restrictor in the valve, so less water passes.


It's a recirculating hot water line used so hot water is available at taps much quicker than with just single hot water line.


Depending upon where you live, there are a variety of lakes, rivers, and reservoirs from which water is taken by municipal water treatment plants, to be purified and disinfected before being sent through the pipes to people's taps.



Sumi has written: 'Who Puts Water in the Taps' 'A village in a million' -- subject(s): Power resources 'Who puts the water in the taps?' -- subject(s): Citizen participation, Drinking water, Environmental health, Sanitation


One who deals with plumbing - water piping, taps, waste water pipes and similar.


Reservoir/ water catchment areas Desalination of sea water NEWater Water from Malaysia


Drink a lot of water and run the taps.