Heater Cores and Blower Fans
Ford Crown Victoria

Fan blower speeds on Crown Victoria?

123

Top Answer
User Avatar
Wiki User
Answered
2010-01-01 18:41:13
2010-01-01 18:41:13

The blower is a multi speed unit.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Blower fan resistor controls electric current to the fan motor to maintain different speeds.



Check/ replace the blower resistor. Located in the duct work under the hood. Follow the wires from the blower motor to a plug on the duct work. This is the resistor


coolant fan temp sensor 1998 crown victoria


the heater blower resistor is bad. located on firewall under heater hoses two 8mm bolts. about a twenty dollar motorcraft part. easy repair.




there is no fan belt. the fan is electric-motor powered.



the blower motor resistor is broken, get a replacement.



There isn't a transistor but there is a blower motor resistor. The purpose of it is to control fan speeds. Normally when it goes bad it will let the fan run on high only. It is located under the dash on the passenger's side near the blower motor.


Could be hi-speed fan relay or secondary winding in blower motor



If you do not have fan speeds it may be a fuse or the blower motor resistor. For help with the issue visit our enthusiasts forum at www.trailvoy.com


You have to be more specific. Which fan? Blower motor for the heat/ac.......clutch fan for cooling.......electric fan for cooling.....? Wish I could help, if you can add more info, just send it to me on my board.


If the fan runs in high but not the other speeds the resister is bad. Done.


Elect. fan for the rad. most likely a bad sensor.


Short of it is the resistor controls the fan speeds for the blower. Easy to replace and to my knowledge only available through a dealer.


If the heater fan works on all speeds, then the blower motor, blower fuse, blower relay, and blower motor resistor pack are all good. If the fan runs but nothing comes out of the vents, you have a 'mode door' issue (which might include a bad control head).


You have a bad blower motor. i have seen a lot of the switches go bad turn on the fan and try pushing down on the fan switch and see if the fan comes on Just to add a liitle to this reply generally if it is your fan switch not all of the speeds burn out at the same time so try turning the switch to every position if any of them turn on ur fan than its just the switch if none of the fan speeds work than it is your blower motor.


Check for 12V at the blower motor connection with ignition on and while selecting all blower speeds with fan switch. If you have power with all speeds at that connection you probably have a bad blower motor. If you don't have power there with any speed selected you probably have a faulty fan switch. If you have power there with only some of the speed selections you probably have a bad speed resister. If you power there at all speeds but high you probably have a bad high speed relay.


if you lost one or two fan speeds you need to change the blower motor resister. it sells for around $60.00 at a dealer only.



The Nissan uses a series of resistance wires to change the speeds on the blower motor and this unit can be found in the heat box right near the fan motor. It is in the airstream after the fan to allow cooling of the resitor wires by the air produced by the fan



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.