The thermostat housing is behind the camshaft sprocket. Remove timing covers and belt then remove camshaft sprocket and then rear timing cover. .
How do you change a thermostat on a 2001 Pontiac Grand Prix 3.8 gtp
take apart the thermostat housing and pop it out be sure and replace the gasket too. There should be two bolts holding it together.
follow the top radiator hose to the engine. that is where your thermostat is. you will have to drain the radiator, remove the engine side of the hose and remove the thermostat housing to access it. remove thermostat clean mating surface of housing and engine, install thermostat, install housing, secure radiator hose, fill with coolant. start engine and check for leaks.
To change the thermostat in this Lexus model, follow the upper radiator hose to the aluminum housing--the thermostat is located in that housing.
there is no 2.0l Pontiac lemans.it must be a swap from sunrunner.
Remove the 2 bolts at the thermostat housing. The upper hose goes to the thermostat housing.
Remove the water supply line to the thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and replace it with the new thermostat.
The thermostat on a 94 Kia Sephia is located in the thermostat housing which is clamped to the radiator hose. To change it, remove the boltsÊon the thermostat housing, pull the thermostat out and replace a worn gasket. Ê
Remove the water supply hose from the thermostat housing. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.
The thermostat is located inside of the thermostat housing. It is on top of the motor where the top radiator hose connects. you will have to disconnect the hose to remove the thermostat housing.
Thermostat is the whole water outlet on the waterpump.
thermostat is located under radiator cap!
Drain the water from your radiator. Remove the radiator hose, from the thermostat housing. Remove the thermostat housing retaining bolts. Replace the thermostat housing gasket and reverse the process to install the new thermostat.
Drain the radiator. The thermostat is in a housing connected to the water pump. Remove the housing to replace the thermostat and gasket.
One can change the thermostat on a Chevy car by draining the coolant and disconnecting the upper radiator hose. The thermostat housing is then unbolted, the old thermostat removed, and a new unit placed in the housing.
Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.
Remove the water supply hose from your Chevy Equinox thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.
The thermostat is under the housing that the top radiator hose connects to, remove the hose then the housing and change the thermostat. The bolts are metric so be prepared with the proper tools.
The thermostat housing is where the lower radiator hose attaches to the engine. remove the hose and the housing (2 bolts) and the thermostat is in there (it may come out with the housing)
Begin by removing the water supply hose to the top of the thermostat housing. Remove the thermostat housing retaining bolts. Lift the thermostat out and drop in the new thermostat.
Raise or lower the temperature to change the reading on the thermostat.
Remove the water supply hose from your 1987 Chevy Astro thermostat housing. Remove the thermostat housing retaining bolts. Remove the old thermostat and drive in the new thermostat.
Drain the water from the cooling system. Remove the water hose from the thermostat housing. Remove the thermostat housing retaining bolts. Reverse the process to install the new thermostat.
The thermostat housing is on the bottom radiator hose under the battery. The battery and bottom hose will have to be removed, then the thermostat housing can be unbolted to remove the thermostat.
You have to remove the intake before you can gain access to the thermostat housing