The turn signals operate through the Hazard switch. The Hazard switch assembly is in the radio console inside the car and must be replaced. This unit is about $90 CDN and can be purchased from the dealership. I replaced mine by pulling out (Carefully!) the radio console (the owners manual will show you how to do this). After that, you: Push the old Hazard Switch out from the rear of the radio console. Unplug the wire at the end of the broken Hazard switch. Plug the wire into the new Hazard switch. Push the Hazard switch back into the radio console and slide the radio console back in place. It takes 2 minutes if you get someone to hold the radio unit while you change the switch. Good luck!
More than likely this is caused by the relays. They are both the same relays and anywhere carries them.
the relay needs to be replaced. you will find it behind the hazard switch (attached to the switch - a long skinny thing) I looked forever till someone told me where it was. Even the Volvo parts guy didn't know and Lawrence Volvo of Walnut Creek, CA would not tell me...
change the relay. it works. cost was $80. part+service
Yes. The relay that controls the turn signals is built in the switch.
The vast majority of the time it is a defective Flasher Relay. Replace it.
Well so far I have found that when I turn my headlamps on and switch to the high been and then use the rocker switch for the hazards, it will allow for my turn signals to start working again.
It's on the Steering wheel. With a hazard symbol on it.
If its an automatic then your either in winter or a low gear(not flashing) or transmission fault(flashing arrow) But if its manual the non flashing arrow is the recommended time to up shift.
Built in in the hazard light switch.
The flasher device for the hazard lights and turn signals is located to the right of the driver's right knee. Remove the bolster panel at the left of the center console. The flasher is normally a black box about 1"x2".
my car dem not working is not working
its inside the hazard switch, usually tapping on the dash over the hazard switch will make it blink again