answersLogoWhite

0

  • Headlights Tail and Brake Lights
  • Nissan Pathfinder
  • Ford Expedition Eddie Bauer

High beam only works on driver's side replaced bulb and checked all fuses low beams work fine?


Top Answer
User Avatar
Wiki User
Answered 2009-10-04 17:48:45

I just replaced my bulbs and I also have the same problem. I have a 99 Toyota Camry and replaced with 7000k Xenon bulbs? Have you found the solution yet?


I had the same problem with my 94 Nissan Pathfinder, the turn signal switch needs to be replaced. I didn't find this until all my lights went out including my dashboard and the low beam was the only lights working.
001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Why does my drivers headlight not work on your 97 expedition already replaced the bulb and checked the fuses?

You have a broken wire.


Why would the high beams work but not low beams and break and tail lights only work if instrument panel lights work 1986 300zx have checked bulbs and fuses replaced switch behind brake pedal?

headlight switch


Your headlights or radio wont work but high beams do what could be the problem?

have you checked your fuses? it could be as simple as that This is true, there is a separate fuse for the high beams, low beams and radio. Fuses for 1999 LHS are located behind a side panel (drivers side) of the dash next to the steering column. Driver's side door must be open and there is a wiring diagram on this panel.


Why would your low beams not work if the fuses have been replaced and the headlights have been replaced and the relay box has been checked?

Often it can actually be a faulty turn signal!! As silly as this sounds it is quite common. First thing to do is clean the contacts on the turn signal, if you still get high beams and no low beams you probably need to replace the turn signal switch.


My 98 Chevy Cavalier has no drl low beam headlights but the high beams work I checked the wiring to the headlights 12 volts checked fuses drl relay and replaced column switch. What is wrong?

You didn't mention if you checked/tested the low beam headlamps or not.


Why won't your vw passat start?

I checked fuses and replaced blown fuses and now it won't start.


How should you go about fixing a headlight issue on a 2003 Outback Wagon Believe there is a runner issue. Checked and replaced fuses and tried 3 new bulbs and only right headlight is funcional?

Are both low and high beams out?


Why would 2004 Monte Carlo lowbeams not work High beams do checked fuses and bulbs what else could be the problem?

Headlight dimmer switch is defective


Toyota Starlet clock interior light and dash board are not working fuses are fine?

You say the fuses are fine, i have just had the same problem. is your radio/headunit also not working??? And have you checked the fuses under the bonnet aswell as in the drivers footwell. I just replaced some of my fuses and it worked fine. Make sure your inginttion is off whilst removing/replacing fuses.(unless testing to see if it worked) Hope this helped!


Replaced new washer pump and it still not working for a wrangler?

If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.


I have replaced my coil pick up coil and checked the fuses on my 99 dodge Dakota with no spark where do i look now?

crank sensor


You have replaced the motor and the control switch on your 1992 Cadillac eldorado drivers side window and it still does not work what is wrong?

check fuses?


How do you get your horn to work on your Jeep Cherokee?

Checked the fuses, if none are blown then the switch in the steering wheel probably went bad and needs to be replaced.


Why would the low beams on a Z24 98 not come on when the switch is turned on even after bulbs have been replaced and fuses for what is there are fine as well?

check multifunction switch, modules & relays


Where is the headlight fuse on a 98 Audi A4?

Fuses 18 , 19, 20, 21 are low and high beams. However, it is often times it is the ignition or headlight switch that needs replaced.


When you put your low beams on you only have one headlight that works and you checked fuses and relay that's not it so you have to use your high beams as your lights?

Most likely the vehicle has separate low-beam and high-beam headlight bulbs and you simply have one low-beam bulb that is burnt out.


Why do the drivers side parking lights not work but the passenger side do on a 1998 dodge caravan The reverse and directionals work on the drivers but not the parking lights.?

Aha, another one! Yes, our '99 caravan is acting the same way. I have checked the bulbs and fuses, both checked good. I even checked the wires with a volt meter. No power is getting to the bulb sockets.


What is going on when passenger power windows won't open in a 1988 Camry but the drivers side will and no fuses need to be replaced?

It could be a switch, a connector or the motor.


My 2003 Honda CRV low beams do not work but the high beams do check fuses and bulbs?

try new light bulbs


Why horn dose'nt wrk?

Have you checked your fuses?


How do you use fuses in a sentence?

Example sentence - The fuses in vehicles should be checked carefully.


Why does the drivers side low beam head lamp not work for my 1997 riviera - I have checked all fuses even under rear seat and replaced bulbs Hi beam works lowbeam does not?

Look under passenger side dash right below heater core for relays


2002 beetle power loss to low beams and wipers?

Check your fuses.


Why wouldn't your high beams work in your 2002 Civic low beams work fine The high beam indicator inside the car also does not come on you've checked the fuses and changed the bulbs How could you fix t?

May be a bad relay in power distribution box Could be a bad switch


Why are the low beams not working but high beams work on a 1997 dodge caravan?

Replace the bulb. The low beams and high beams use separate parts inside the bulb. If replacing the bulb does not fix the problem, check the fuses.