answersLogoWhite

0


Best Answer
Copy

Driver's side front to back 1,2,3,4 Passenger's side front to rear 5,6,7,8

User Avatar

Wiki User

โˆ™ 2007-05-11 21:23:43
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How are the valves numbered on a Ford 390 motor for spark plug wires to distributor Are they 1234 down the right side and 5678 down the left Or 1-right 2-left 3-right 4-left and so on?
Write your answer...
Submit

Related Questions

What companies produce radiator valves?

A large selection of companies produce radiator valves. IVAR and MEPCO are two of the largest producers of radiator valves in the US. There parts can be found through their distributor listings.


Where should the timing mars be for top dead center to set valves on a 1987 suzuki samurai?

There is a timing check window in the clutch housing, remove the rubber plug and turn the engine clockwise to find a 'T' punched into the flywheel, that is TDC. The 'T' is over the mark that aligns with the housing. Remove the distributor cap and confirm the rotor is pointing to #1 and set the valve lash **( the valves are numbered from the front 1,2,3,4 on the left side and 5,6,7,8 on the right)** on valves 1,2,5 and 7 then turn the crank 1 revolution and set valves 3,4,6 and 8.


What is the function of cam shaft?

The camshaft's main function is to open and close the Intake and Exhaust valves...On some cars it drives the distributor as well.


Is timing belt and cam belt the same?

Yes, timing is when your cam opens and closes your valves also your distributor shaft which regulates the firing of your plugs.


Replacing distributor on 98 vortech 305 when the old position was not marked. Can you set the engine at tdc and line the distributor rotor up with 1 cylinder position?

Make sure both valves are closed in compression stroke. If not you will be 180 degrees off (exhaust stroke)


What causes misfire?

bad distributor cap or ignition wires (bad insulation damaged when you pull wires out without twisting it ) and less likely burned valves or bad plugs


How did poop and pee get numbered?

it was because of a 2 valve flushing system on some toilets. #1 was a minor flush #2 opened both water flapper valves in order to maximize the flush:)


What would make a 1991 Pontiac Grand Am cough and sputter backfire up the carbarator?

There could be many causes, but the first that comes to mind is that the timing [between the pistons/valves and distributor] has "jumped or slipped," causing the the fuel mixture to be ignited by the sparkplugs, WHILE the intake valves are still open.j3h.


What makes the engine miss.new plugs wires carb valves set the only thing i have not replaced is distributor car and rotor?

When you replaced the plugs, did you check the compression? Did any of the plugs look different than the others? Low compression in one cylinder can cause misfiring. But then, so can a faulty distributor cap.


What are the 2 sets of valves?

Trumpet valves Motorized pumping valves are two sets of valves.


Whats the problem 1999 Chevy 3500 5.7 starts but dies has 60 psi fuel pressure poppet valves work in run but engine dies when started and no fuel from injectors?

change pick up coil in distributor check the triangular points on the round part that triggers the pick up coil corrosion and degrading material common problem requires distributor removal and disassembly of the distributor


Where is a valve in the human body?

There are many valves in the human body. There are valves in the heart as well as valves in the blood vessels. Which valves are you asking about?


What is the difference between atrioventricular valves and the semilunar valves?

When the heart is relaxed, the AV valves are open and the SL valves are closed. When the heart contracts, the AV valves are closed and the SL valves are open.


Do capilliaries have valves?

Capillaries do not have valves. Veins are the blood vessels with valves.


Name three brass instruments that have valves?

Trumpet has piston valves and occasionally rotary valves, Euphonium/Baritone has piston valves, Tuba has piston valves and french horn has rotary valves. Trombone has a slide, not valves but is also a brass instrament.


What is and e valve?

There are two types of valves in an engine. The valves are located in the head. There are exhaust valves and fuel intake valves


Why do lymphatic capillaries have valves in them?

it has valves in them because the valves carries lymph in the capillaries


What vessel has valves?

Veins have valves.


What brass has no valves?

The bugle has no valves.


What are the valves called on a trumpet?

Valves


When are the semilunar valves open?

Semilunar valves are open when the blood is being pumped. The AV valves are closed when the semilunar valves are open.


What are the aortic and pulmonary valves described as semilunar valves?

Not sure what your question is, but yes they are semilunar valvesyour atriaventricular valves are the bicuspid and tricuspid


What causes 1 spark plug to foul and not the rest on Chevy v8?

Bad plug wire, or even bad plug it low voltage going to distributor Also check to see if the valves are sealing properly.


When installing a distributor in a 350 chev does should the number 1 piston be on the compression stroke or intake stroke at TDC or does it matter?

#1 should be up for compression. Both valves would be closed. Addendum: The above answer is correct except for one thing; #1 MUST be at the top of the compression stroke if you want the engine to run, and the distributor MUST be pointing at #1 plug wire. Recognize that the distributor will turn slightly as it drops down into the cam gear, so make certain that you accommodate for that. You want the rotor to be pointing to the center of #1 when the distributor is in place.


How do you install a ford distributor?

Remove #1 spark plug Remove valve cover Manually turn engine until #1 piston is at top dead center Confirm that both valves are closed (compression stroke) Align rotor on distributor so it it pointing to #1 spark plug wire Drop distributor in carefully not to change positon of rotor Replace valve cover and spark plug Final set timing with timing light