Well if you got any old "RCA" cables what i would do is cut the end off of one and wire it to the back speakers and then you plug them in to the amp and then hook up the power supply for your amp and then connect your subs and that should work???
NOTE: THE ABOVE SOLUTION WILL NOT WORK AND WILL DAMAGE YOUR AMP!!!
A typical Head Unit will push between 10 and 50 watts to each speaker, while the RCA inputs on your Amplifier will only take about 3.5 watts. In Stereo World, this is called "Input Voltage." You need a device that will lower the amount of power coming out of your Head Unit, so that your amplifier can receive an acceptable amount of incoming signal. In short, DOING THE ABOVE WILL ABSOLUTELY FRY YOUR AMP.
What you are looking for, friend, is commonly called a "Knockdown," or a "Step-Down-Converter."
This is a device that wires directly to your Head Unit IN PLACE OF a speaker (READ: you have to sacrifice a speaker chanell to do this!), and lowers the speaker signal from the head unit to "Input Voltage" level, so as not to fry your amp (hence the term "Knockdown"). This unit will be about 3"x3"x6" and will have RCA outputs on the back of it to hook up to your amp. Find one here:
http://www.amazon.co.uk/STEREO-CONVERTER-FITTING-AMPLIFIER-VEHICLE/dp/B0029VQRLY
PS: Any Mom and Pop Stereo Shop should be familiar with this item, and should have some in stock, they are very commonly used in your situation, and are not new to the industry.
No.
basically, it is selling the stock you have without buying in any more, so to only create revenue and no costs
The wattage of your stock stereo in your 1989 Acura Integra is 75 watts. There was anÊoption for a larger stereo output of up to 200 watts.
it depends if u are using the stock stereo then no but if it is not a stock stereo then u may have an aux input jack which comes out the back of the stereo the easiest way is to just pull out the stereo and take a look
without removing the stereo you are limited to a cassette adapter or a wireless FM modulator. both will have very low/crappy sound quality. the next step up is a wired FM modulator.. you will have to intercept the antennae connection for this.. best place is behind the stereo but you can also get to it at the antennae itself.
screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version
NO.
No, the Ion and A5 have different threads.
NO there is not.
Buying on margin.
buying stock for a fraction of its cost and borrowing against future profits
Yes, there is a wiring diagram fro the stock stereo for the 1993 Lincoln Continental. This can be find in the maintenance manual.