The cover for the instrument pod that the compass is in is held on by several screws. They are covered by small "buttons" and are towards the front top on both sides. Pry off the buttons (carefully) and you will be able to access the screws. Note that the same bulb is available at any auto parts store for 1/3rd the price Misubish wants for them.
Drive it into your favorite oil change station and tell them your light is out. Within 15-minutes they'll do the work for you. Last time I needed a bulb changed it cost me about $10 for parts and labor.
http://www.partsamerica.com/ProductList.aspx?PartType=301&PTSet=A this should help
1998 Mitsubishi Montero headlight bulb lamp replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
leopen hood of vehicle. The headlamp is in a case that comes out. Headlamp screws in and out of it. Replace, and then put case back in. - Or stop at Auto Store, play dumb and have them do it for you (that's how I found out! )
how do you change the light bulb over the license plate on 2000 eclipse
Open the hood to the engine compartment. Take hold of the headlight light bulb connector. Push the connector in and turn it at the same time. The headlight light bulb will come out. Reverse the process to install the new light bulb.
To change the headlights on a 2005 Mitsubishi Colt, make sure there is no damage on the wire clip. Pull the bulb out gently. Slip in the new bulb and turn it until there is a click. Then put the clip back on.
Your owners manual will describe the procedure.
I am guessing brake lights? But there are two screws inside of the truck that need to be removed - freeing the light (all but the wires) you will then need to remove the bulb by twisting counter clockwise.
Because there is a short in the bulb. Bang on the dash just above the light and see if it comes back on, mine did.
the answer is at http://gtouser.wordpress.com/2008/12/21/how-to-change-the-headlight-bulbs-on-a-mitsubishi-gto-or-3000gt/ so just paste this link in your web browser and you can find out. hi
by puting ur bulb in ur girl friends hole
Mitsubishi Montero Bulb Troubleshooting (check in this order): · Check Fuses · Check Bulbs · Check Relay(s) · Check Light Switch(es) · Check license plate light bulb and wiring · Check trailer hitch wiring harness · Check all wiring harnesses and wire Most likely its the fuse or a burnt bulb breaking the circuit. Sometimes the license plate and/or the trailer hitch is wired into other circuits and can cause issues in other areas. Sometimes its wires grounding out somewhere on the vehicle. See sources and related links below for bulb information. See owner's manual for location and identification of fuses as well as for bulb replacement procedures.
http://www.monterosportonline.com/diy-ext1.html Mystery solved, though it may not be as easy as a normal truck bulb replacement. Good luck!!
I took a few screws out of the front wheel well mud guard behind the marker light and reached in through there to remove and replace the side marker light.
there are plastic covers over them on the inside of the trunk that you pop off
shogun side light bulb
See sources and related links below for the 2002 Mitsubishi Lancer headlight bulb info.
2 screws 1 on top of the light(open the hood) the other is hidden behind the metal facia on the bottom facing forward,then pull light forward careful not to break the plastic tabs off. twist the bulb holder to the left and walla there it is
Phone your local Mitsubishi dealer
how to replace bulbs on a 2009 mitsubishi eclipse
peel off carpeting behind the tail light from the trunk. there should be bulb holders- pull out the holder that holds the busted bulb. you can do this by slightly turning it and pulling it out. change the bulb and replace the holder the same way you removed it.
Just twist the bulb socket from under the hood behind the headlampand do not touch the new bulb glass with your fingers when replacing it or it will prematurely fail.
In the front wheel well there are platic screw latches that hold wheel well coul in place. Remove the front ones to gain access to side marker light compartment.
In a 2004 Mitsubishi Lancer replacing the rear light bulb is relatively easy. First remove the plastic cover from the dome light. Unscrew the light bulb and insert the replacement.