To disable the running lights either unplug the relay to the fuse box. Also there is a fuse for this in the fuse box remove this and that will disable the lights.
On a 2006 passenger van the lights will go out after several minutes on their own. There may be some way to change that in the computer...?
How do you disable the DRLs on a 2005 Mitsubishi Endeavor?
try pulling the drl relay located inside the hood passenger by side headlights. Or pull the fuse to the relay. Good luck,
I believe there should be a photo sensor on the top of the dash, normally on the passenger side. I had the same problem with my Chevy Tracker lights. I lifted the sensor cover and unplugged it then put the cover back on.
Remove the fuse.
Press a button.
There is no way to disable the DTrs while driving, they are a safety issue. To turn off the DTRs, push down slightly on the parking brake pedal and the lights will go out.
No, but there are reading lights made for the nook and available for you to purchase.
You can easily change to regular lights, all you have to do is bypass the amp that's located behind the radiator on the passenger side. Make sure you disconnect the battery before you touch ANYTHING, because the amp creates enormous amounts of power that could actually be fatal. Hard to imagine from a 12V Battery right? Once you bypass the amp, you'll have to find a way to fit a regular bulb in your hid light sockets...just be creative.
slightly apply the E brake
Try a hammer.
To disable the daytime running lights on a 2008 Sequoia, turn the head light switch to the center position. It should show two headlights, one with an 'X' and a line between the two.
Hit 'em with a big hammer
Our daytime running lights just stopped working on our 2007 Toyota rav4 bulbs???
when I replace the fuse for the interior lights on my 2004 CVR the alarm sounds, can I simply disconnect the power to the alarm (if I can locate it) to disable it,......
press your ebrake one or two clicks and leave it on
Cheapest returnable answer is to remove the bulbs
The new Polo (2011) does not have "Daytime driving lights". It is fitted with "Permanent driving lights". The lights on cars with Daytime running lights can be switched off by using one of the stalks on the steering wheel, or by removing a fuse (daytime driving lights are on a seperate light circuit) Permanent driving lights cannot be switched off. If hte fuse is removed it will disable your headlights and backlights altogether. The only way to disable it is to remove the rotary light switch and cover the pin marked "TFL"
the antitheft lights blinks the car cranks but doers not start
you have a blown fuse not for sure which one but it is on the passenger side
2001 GMC Savanna Van Daylight running lights. Do I need to disable the daylight running lights so I can install HID lighting system, for it to work?
Remove the fuse on the interior fuse box
Yes, there is a fuse for the interior lights on a 2000 Pontiac Montana. The fuse box is located to the far right of the dash on the passenger side. Open the passenger door to access it.