pcv valve is in the valve cover across from yhe intake plelum
To do a valve lash on a 2003 Honda Accord make sure a lash gauge is on hand. Valves lashes adjust the valve to piston clearance on cars. Be sure to use the appropriate specifications of clearance for the 2003 Accord.
pop the hood and find your brake fluid resouvier take the lid off and see if its full its that easy
It is inside of the fuel tank.
HI, I would suggest you check the ignitor .My 1993 Honda Accord LX had the same symptoms. Mary
I have a 2000 Tacoma 4x2 and it uses Dextron II. Pull out the dipstick where you check the trans fluid level and it should be stamped on it.
The 2.2L engine doesn't have a distributor.
1, 3, 4, 2.
put your pp in the pistons
Mazda recommends replacing the timing belt every 60,000 miles. If you didn't do it at 60,000, DO IT NOW. Not sure if this is a zero-clearance engine, but I don't believe it is.
how do you set the timing belt on a 1997 ford contour 2.0 4cy
List make, year, model and engine. Try again.
part number for ford ranger dipstick T379221
The firing order for all of the Chevy Celebrity 4 cylinder engines is: 1 3 4 2
Answering my own question. Repleace with original Champion RC9YC plugs, do not upgrade to platimum. Car immediately ran great and initial hesitation was "gone".
No. The entire driveline would need to be replaced. You could if you change the engine, trans, wiring , computer, radiator,.......
The firing order for a 1987 Chevy Celebrity with the 2.5L 4 cylinder engine is: 1 3 4 2
In My 1995 Ford Ranger 4 cylinder i get 27mpg but my uncle had a 1994 4 cylinder and he got 30 mpg
Screwed into the head. Take off the metal cover on the top of the engine (4 bolts)and the plugs are under it there are not attached with wires but boots
If the rotor of the 2001 Honda Accord will does not have mounting hardware it is pressed on. To remove these types of rotors the caliper will have to be unmounted. The rotor will then come off.
new timing belt every fifty 50,000 mi. yes it is an interference head
Only that motor will fit unless you change out the transmission & transfer case. They are different on 4 cyl & 6 cyl
Solenoid on inner fender? + battery cable to large terminal Cable from starter to other large terminal Trigger wire to either small terminal