The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.
its a vacuum line it goes from the belt side at the back and runs behind the engine and down the drivers side and under the battery to the pod under the skirt in the front wheel
I belive that there is no adjustment on the serp belt on your lumina. Should be a spring loaded tensioner. If you are having problems with the belt slipping you most likely need to replace the belt/ tenssioner.
To repair a seat belt that does not retract, the first thing to look for is something that is stuck in the seat belt housing. Sometimes things can fall into this area and jam it up. Also check for a twisted seat belt.
slide a crescent wrench onto casting on front of tensioner, pull up towards rear of car to release tension and remove belt Do A Barrel Roll
The 1990 has a chain. The 1991 has a belt.
ELR - Emergency Locking Retractor..Seat Belt Retract you when you face collision.
It has a serpentine belt that runs all the accessories not just the fan
A seat belt that will not retract in a 1993 Altima might be twisted in the mechanism on the floor of the vehicle. This part of the seat belt mechanism should be taken apart and inspected. If possible, try pulling it out as far as it will go and then see if it will retract.
Take it to the dealer the seat belts have a life time warrantee form Nissan they will fix them for free. Check the warrantee section of you user manual.
the single belt that runs around the engine, alternator, a/c and water pump is the serpentine belt.
Pull off the panal that houses the belt and check for twisting or binding.
usually serpentine belts get their tension(tightness) from the belt tensioner
yes you could take it to a dealer BUT the car is too old.....sorry we dont have that part! if you look right in front of the back seat there is a access panel, pop it out reach inside you can feel the seat belt motor... on top of this motor is a turn knob turn the knob clockwise the seat belt goes back turn counter clockwise it goes forward..
it doesn't have one
why is there an asteroid belt in front of jupiter?
Your limit switch is probably dead. The automatic shoulder belt has a limit switch at each end of the track. When the belt reaches a switch the motor stops turning. If the door is opened, the motor will keep turning one way until the front limit switch is pressed. When the door is shut, the motor will turn the other way until the back limit switch is pressed. If the front switch is shorted, then it's always telling the motor that the seat belt is extended. So the motor wont extend the seat belt at all. But if you manually extend the belt and shut the door, the belt retracts because the rear limit switch is fine.
Find the idler tensioner pulley and retract it. You then will be able to easily remove and replace the belt.
it is on the drivers side front of the block behind the timing belt cover. you can fallow the lower rad hose to it. it runs off of the timing belt.
looking from the front, on the drivers side, front of the engine, pump and reservoir with a belt attached to it, black cap about 2inches across