Starters and Ignition Systems
Chevy Blazer
Nissan Xterra
Grand Am SE

How can you get the key out of the ignition of a 2003 Exterra?

484950

Top Answer
User Avatar
Wiki User
2006-04-05 20:25:08
2006-04-05 20:25:08

Turn completely counter-clockwise.......and pull out.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.

User Avatar

Wrong key - or - defective ignition switch.

User Avatar

If your 2003 Nissan Exterra will not turn over and is not getting fire, you may need to replace the batteries or the spark plugs. You might also have a wiring issue or an issue with the fuel injectors.

User Avatar

My envoy did this also when the battery died. installed new battery and key came out.

User Avatar

The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.

User Avatar

you can program a key if you already have two known good keys. if not you will have to pay the dealer or a locksmith

User Avatar

according to my gm dealer it does not. The passlock system is in the ignition cylinder

User Avatar

you havent taken the key out of the ignition.

User Avatar

Put the key in the ignition and turn it into the run position, but don't start the car. Leave the key in the ignition until the security light stops flashing. The car will start now.

User Avatar

Put the key in the ignition in front of hand brake next to the gear shifter.

User Avatar

Yeah sure, its that thing you stick your key into to start it.

User Avatar

it is either the key is worn out or the key cylinder in the ignition is worn out.

User Avatar

You must replace the ignition switch if you cannot get the key out.

User Avatar

1996 rodeo- how to remove key from lock ignition?

User Avatar

No a diode will not work when the ignition key is off.

User Avatar

There are several things that can cause a key to get stuck in the ignition. You can try turning the steering wheel a bit to the left or right to see if that allows it to release. Also, try pushing the key in a bit more and turn it to the lock position, then try pulling it out. Don't force the key or it could break off in the ignition.

User Avatar

There's a button under the the key on the ignition terminal. Push it and pull out the key!

User Avatar

Removing a ignition lock cylinder from a 2002 ford windstar with no key

User Avatar

leave the key in the ignition over night key should reprogram

User Avatar

Remove and bring to an auto parts store that can check it for drag and load


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.