to use asphalt millings to repair drive, the best thing to do is to aquire what is called tack, froma paving company. put some of this in with the millings. once the millings have been put in pot hole and rolled , it will set up after a few days of shunshine. should not move again ps: tack is the sticky black oil that is sprayed on a road before putting the asphalt down,to make it stick and bind the 2 sufaces together
Pot holes
This question is too specific as roads would be less expensive than a drive because of the quantity. However assuming the question was based on a driveway it should be about $.85 to 1.25 per square foot. Once the base coat on your driveway has been applied it is best to give it time to set up perhaps 6 months or longer if possible. This is because a new driveway is likely to develop small pockets and sink holes due to settling and water flow changes. Although a driveway can be repaired when this happens it never looks the same as if it were done at the same time.
There already are black holes.
There are already black holes within the universe
If it has the holes already just put the fins in and screw them in from the other side.
Where cracks form in the asphalt/concrete, repair crews fill the cracks with tar to keep water from seeping in and widening the cracks into pot holes.
First, in order to accomplish this task, be sure the plastic flange fits the opening in question. It this is new work and anchor bolts or anchorbolt holes are not already in place, fit the flange to the lead drain line as you want it to go and by this guide, using a cement bit, drill holes in the cement(assuming the basement floor is cement). Two holes are required. After the holes are drilled, force lead inserts into the holes. These are to screw the anchoring bolts into to hold the flange stable. Choose the correct lead inserts and the side drill bit to match. Any hardware store can match these up for you. The remount the flange, through the proper holes in the flange, the ones you used as a guide for the holes, then insert the ancholr bolts and tighten down. It Holes are already in place and no lead inserts are already in the holes, simply obtain the proper inserts, bolts and Voila! do according to the above, simple yes?
I remove the door, weld up the holes and redrill them to the correct size.
probably not. skunks have claws for digging, but they mostly dig for food. they also mostly use holes that were already dug as their den. making small holes like those aren't skunks' habbit
no the caustic soda used are already reacted with the fatty acids and glycerol in the soap making
No, they are just a form of expression. Some people say "The Lord doesn't want holes in your face." I tell these people that if that was the case, there wouldn't already be holes there [i.e. nostrils, mouth]. They never have a response to this, so I have no reason to believe it is a sin.
Cygnus X-1; Sagittarius A* Actually, any observed black hole can be assumed to have been a star at some moment; although in the case of the supermassive black holes, it is not quite clear how they formed.