put it into park, i made the same mistake and couldn't get it out for ages!
You will have to drill the center out to get it to turn.
No such part on a 2002 Jeep Grand Cherokee.No such part on a 2002 Jeep Grand Cherokee.
In the key
make sure the transmission is in Park. then turn the steering wheel to the left and right while trying to remove the key.
how to remove key stuck in ignition switch in Chevy colbalt
I have a jeep 1994 Jeep Grand Cherokee and found this answer on this site under programing a 1995 jeep Grand Cherokee. Its a very good description uses the same FOB.
turn the key
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
I have a 1997 Grand Cherokee, and my key fits both the door and the ignition.
brake a window
get a locksmith
The 2002 Jeep Grand Cherokee ignition key brain box is located behind the dashboard. The brain box will be on the drivers side of the dashboard.
I had the same problem. Google "keyless entry remote 2003 Jeep Grand Cherokee".
Have to take it to the dealer.
You unlock the door with the key or remote.
If it is gray, then yes.
There is an access cover just under the ignition cylinder. Remove this to remove the stuck key.
1. Remove the lower steering wheel shroud. For a 1998 Jeep Cherokee it is connected with three #2 Phillips screws underneath. 2. Put the key in the ignition, turn the ignition to ON. On the key cylender, in the middle bottom, is a rectangular button. Press it all the way in, with a small bladed standard screwdriver. 3. Pull the key cylender out. Reverse steps to reinstall.
Try turning the steering wheel back and forth while turning the key.
Dealer only on 96+ newer Jeep Grand Cherokee's
With the dealers scan tool.
Programmer and PIN # required