Join ALLDATA.COM, SIGN UP COST $14.95 A YEAR BUT WELL WORTH IT. IT'S AN ONLINE TECH MANUAL JUST FOR YOUR VEHICLE.
It is important to use the right type of transmission fluid in a car. A 1994 Chevy Corsica take Dexron III transmission fluid.
It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
take out the 2 bolts that hold it
You have to take the door apart
Too my knowledge there is no such animal. Describe the part and what it does, where it is located.
First you have to find out where he is.
take the old one off, put a new one on.
Take the drum off and take a picture. Use one wheel as a guide to repair the other.
Sometimes you have to cut the dash hole bigger. I suggest you take it to aomeone willing to tackle it.
along the firewall. take the black cowling pieces off and look near the center of the firewall.
located in the fuel tank of a 1992 corsica ,it may be the same for your model if this is so you may need to drop the tank . I would notadvice you to take on this job unless you have to.
A 1994-2004 Chevy S10 has a capacity of 4.5 quarts.
just take the tires off the back and the hubs should be free to move. if not, try prying a little, but be careful.
If you have to ask how to perform this very simple, basic task, take it back to the Chevy dealer and let Mr. Goodwrench do it.
There are several safety mechanisms for the Chevy Corsica. if you accidently left the car out of park when you turned of the car, in some models if your lights are left on it wont let you take out the key.
I had to take the bolts off of the fan. Remove the plastic fan cover. Diconnect 2 hoses underneath. Watch for oil. disconnet hoses on top. Unbolt radiator and remove. Make sure all hoses fit on new radiator. I have to remove twice since i didnot check
Check the fluid. If full, take it to the trans shop.
ther is a tesionor pulley that releives pressure to the belt. it should take a 5/8 wrench
First you have to jack the car take off the wheel then remove the brake caliper then remove the sway bar bushing ,then remove the lower ball joint from the shock then remove the bolt that holds the lower control arm in . one towards the front and one towards the back . then remove the control arm . press out the old bushing and press in a new one then revers the procedure.
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
Installing a standard transmission in a 1994 Chevy z71 is easy. All you have to do is take the old one out and put the new one in and tightening the bolts back.
TAke the wheel off and then take the caliper off and the rotor will then come off.
You have to take the control arm and ball joint to a shop and have them pressed together, otherwise it is easier to buy the new control arm with the ball joint already in it.