Bearing & seals will run you about $150-$200 for parts and about 2 hours labour
The 1999 Nissan Ultima fuel filter is located in the fuel tank. The fuel filter is not visible and is very costly to replace.
Timing chains are designed to last the life of the engine and are normally replaced during a complete engine rebuild. If you change your oil/filter as recommended by the manufactrue you will not need to change it. If your 2008 Nissan Altima needs a new chain then you either have neglected the oil changes or there was a factory defect. Talk to your Nissan dealer about warranty service on this.
the relay is built inside the motor. might need to replace the motor..could be costly.
Subtitutes
reds are usually better for performance, but it all counts on your budget, abecs are alright for their price and reds are high end performance bearings that are costly, your choice
The vibration usually measured on the bearings of machine because bearings are often the place where damage occurs and where symptoms first develop. Vibration measurements are usually taken at machine bearings, with accelerometers mounted at or near the bearings.
The compressor will seize. They are very costly to replace.
why would you do that?
You have a hydraulic clutch, most if not all of this type do not have an adjustment. Most likely suspect is the slave cylindar on the transmission. That or the master cylindar, but the slave is more likely. Put a repair kit in or replace slave cylindar. Neither is very costly.
Yes it is possible although it is costly and not so easily got.
The cost of motor mount replacement varies from car models. Some are easy to replace and are inexpensive, while others are complicated and costly.
CV joint can fail, if the RPMs are fast enough you can tear up the transmission and differential, you will lose all drive power to the wheels and you will be stranded in the middle of nowhere, dont put off getting a cv replaced it can get costly if you break one!